Hempel Hempatex Enamel 56360

SKU
id21339
UN1263 (Class: 3, Pk Grp: III)
A finishing coat based on acrylic resin and non chlorinated plasticizer for optimum gloss and colour retention.
Available in 5 and 20 Litres. Tintable to many RAL and BS shades.
From £48.67 £40.56
In stock
Only %1 left
Product Description

Hempel Hempatex Enamel 56360 is a finishing coat based on acrylic resin and non chlorinated plasticizer for optimum gloss and colour retention. Resistant to salt water, splashes of aliphatic hydrocarbons and animal and vegetable oils.

Best Uses

Hempel Hempatex Enamel 56360 is formulated as an interior and exterior finishing coat in HEMPATEX systems in moderately to severely corrosive environment.

Application

Preparation For New Steel: According to specification.
Preparation For Repair and Maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Remove all rust and loose material by abrasive blasting or power tool cleaning. Dust off residues. Touch up bare spots to full film thickness.

Apply only on a dry and clean surface with a temperature above the dew point to avoid condensation. In confined spaces provide adequate ventilation during application and drying.

If a skid-proof surface is desired, sprinkle while paint is still wet HEMPEL'S ANTI-SLINT 67500 evenly on the first coat of: Hempel Hempatex Enamel 56360. When the paint is dry, sweep up surplus grit and apply a second coat of: Hempel Hempatex Enamel 56360. Antiskid properties can be obtained by mixing 1.0 kg of Hempel Anti-Slip Beads 67420 into: 20 litres Hempel Hempatex Enamel 56360.

Technical Details
Components: Single Pack
Type: Acrylic Resin
Finish: Gloss
Stock Colours: 10000 White
Tintable: Yes, to most RAL or British Standard codes. Please note, bespoke tints are non refundable / exchangeable
VOC Content: 594 g/L
Volume Solids: 32%
Suitable Substrates: For use within a Hempatex System
Application Method: Airless spray / Air spray / Brush
Theoretical Coverage: 9.1 m2 per litre in 35 microns
Wet Film Thickness (WFT): 100 microns
Dry Film Thickness (DFT): 35 microns
Induction Time: -
Pot Life: -
Surface Dry: 1 hour at 20°C
Overcoatable: According To Specification
Thorugh Dry: 1 hour at 20°C
Cleaner / Thinner: HEMPEL'S THINNER 08080
Shelf Life: 5 years (25°C/77°F) from time of production
Packaging: Available in 5 and 20 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Recommended products to use