Hempel Shop Primer E 15275 is formulated as a shop primer for protection of blast cleaned steel plate and other structural steel during the storage and building period.
New steel: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Abrasive blasting to the cleaning degree specified for the final coating system, usually Sa 2½ (ISO 8501-1:2007). Apply immediately after cleaning. All damage of shop primer and contamination from storage and fabrication should be thoroughly cleaned prior to overcoating. For repair and touch-up use: primer specified for final coating system.
Apply using Airless spray / Air spray. Use a brush for touch up only.
|Stock Colours:||50890 Red|
|VOC Content:||637 g/L|
|Suitable Substrates:||For blast cleaned steel and structural steel|
|Application Method:||Airless spray / Air spray / Brush (touch up)|
|Theoretical Coverage:||10.4 m2 per litre|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||15-25 microns|
|Pot Life:||24 approx. hours at 20°C|
|Handle Dry:||6 minutes at 20°C|
|Overcoatable:||See product data sheet|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||HEMPEL'S TOOL CLEANER 99610|
|Shelf Life:||See tin|
|Packaging:||Available in 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.