£7.75 delivery on orders excluding certain products & postcodes *
PPG Hi-Temp 1027 HD is 2-pack coating that can be applied and then shipped next day will little/no damage from straps/chains in transit. Offers improved coating for modular construction.
After transit, use PPG Hi-Temp 1027 on site for welds and touch up etc.
Non-insulated service: carbon and stainless steel
Insulated service: carbon steel
Insulated service: stainless steel
Substrate conditions of carbon steel for insulated and non-insulated service
Must be free of oil, dirt, grease and all other contaminants, especially salts. Round off all rough welds and sharp edges. Remove weld spatter. Recommended dry abrasive blast cleaning to SSPC-SP 6, “Commercial Blast” (ISO-Sa 2) with a 25 to 50 μm (1.0 to 2.0 mils) profile
Substrate conditions of stainless steel for insulated and non-insulated service
Must be free of oil, dirt, grease and all other contaminants, especially salts. Round off all rough welds and sharp edges. Remove weld spatter. Small surfaces may be cleaned with a chlorinated-free solvent. Large surfaces may be cleaned utilizing a high- or low pressure wash or steam cleaning with an alkaline detergent (such as Prep 88), followed by a freshwater rinse. Water used should be potable grade or better and should be checked to assure minimal salt content. Do not use any chemical
additives in the rinse water.
Note: Do not use chlorinated solvents on stainless steel surfaces
Substrate temperature and application conditions
Substrate temperature during application should be between 10°C (50°F) and 66°C (151°F). Substrate temperature during application should be at least 3°C (5°F) above dew point. Relative humidity during curing should be above 20% and below 90%.
Apply via brush, roller, airless or air assisted spray as per data sheet recommendations.
Components: | Two Pack |
Type: | Ambient cured multi-polymeric heat resistant coating system |
Finish: | Flat |
Stock Colours: | Grey |
Tintable: | No |
VOC Content: | 408.0g per Litre |
Volume Solids: | 65% |
Suitable Substrates: | For CUI protection of carbon steel and stainless steel |
Application Method: | Brush, Roller, Air Spray or Airless Spray |
Theoretical Coverage: |
2.6 m2 per litre at 250 microns 2.2 m2 per litre at 300 microns |
Wet Film Thickness (WFT): | |
Dry Film Thickness (DFT): | 125 - 300 microns |
Induction Time: | - |
Pot Life: | 6 hours - 8 hours at 20°C |
Touch Dry: | 2 hours at 20°C |
Overcoatable: | 16 hours - 24 hours at 10°C |
Fully Cured: | - |
Cleaner / Thinner: | PPG Thinner 21-06 |
Shelf Life: | 12 months unopened in original packaging stored cool and dry |
Packaging: | Available in 12 Litres |