Interbond 201 is recommended for use as an anti-corrosive primer/finish for decks, deck fittings and cargo holds and hatch covers on external decks. It is suitable for both major refurbishment, and on board maintenance.
The recommended application method is by Airless spray or Roller. A brush can be used for small areas only. Please note that application by conventional spray is not recommended.
Use in accordance with the standard Worldwide Marine Specifications. All surfaces to be coated should be clean, dry and free from contamination. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning.
Please see the product data sheet for full surface preparations and application details.
When spraying large areas, application of a brush coat is recommended over pitted or rough surfaces to ensure full penetration. Stripe coating of complex structures is recommended.
Interbond 201 low temperature grade is not suitable for use in Ballast Holds.
Optimum performance is achieved when Interbond 201 is applied over blasted steel.
In common with all epoxy based coatings, Interbond 201 will exhibit chalking of the film on UV exposure.
When used as part of an approved scheme, this material has the following certification:
|Stock Colours:||KDL549 Signal Green, KDL274 Red, KDK724 Storm Grey, KDF684 Surf Grey|
|Tintable:||Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||279 g/lt|
|Application Method:||Airless spray, Brush, Roller|
|Theoretical Coverage:||4.93 m²/litre at 150µm dft|
|Wet Film Thickness (WFT):||203µm|
|Dry Film Thickness (DFT):||150µm|
|Pot Life:||4 hours at 25°C|
|Touch Dry:||4 hours at 25°C|
|Overcoatable:||Dependent on overcoating product used. Please see product data sheet for information.|
|Hard Dry:||9 hours at 25°C|
|Cleaner / Thinner:||International GTA220/GTA822|
|Shelf Life:||12 months from date of production unopened|
|Packaging:||Available in 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.
A 2 pack epoxy zinc phosphate primer suitable for the anti corrosive protection of carbon steel surfaces.