Johnstone’s Aqua Water Based Gloss is specially formulated to give all the application and appearance characteristics of traditional gloss with the added advantage of being quick drying and low odour during application. Johnstone’s Aqua Water Based Gloss should be used in conjunction with Johnstone’s Aqua Water Based Undercoat to give the best possible finish.
Suitable for interior and exterior use. Ideal for interior and exterior wood and metal.
All surfaces to be painted should be clean, dry and free from loose and flaking material. Prime bare wood surfaces with Johnstone’s Aqua Water Based Undercoat. Prime all other bare surfaces with the appropriate Johnstone’s primer. Rub down previously painted surfaces with fine waterproof abrasive paper and rinse thoroughly. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding. Special precautions should be taken during surface preparation of pre-1960’s paint surfaces over wood and metal as they may contain harmful lead.
Stir well before use. Easy to apply by brush. Avoid overspreading. Do not apply in temperatures below 10˚C or externally when rain is imminent. For best results use a good quality synthetic brush.
|Tintable:||Yes to Johnstones 16,000 Colour Range. Please note, bespoke tints are non refundable / exchangable.|
|VOC Content:||Low VOC content 0.3–7.99%|
|Suitable Substrates:||Ideal for interior and exterior wood and metal|
|Theoretical Coverage:||10 - 12 m2 per litre|
|Wet Film Thickness (WFT):||91μm|
|Dry Film Thickness (DFT):||38μm|
|Touch Dry:||1 - 2 hours|
|Recoatable:||4 - 6 hours|
|Cleaner / Thinner:||Water|
|Packaging:||2.5 and 5 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.