Jotun Penguard Tie Coat 100

Formally Jotun Penguard Tie Coat. A 2 pack, polyamide cured, high molecular weight epoxy coating.

Available in 18 Litres in Red

* These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.

2. Size

3. Select a Qty

As low as:

£236.72

Inc VAT £284.06

PRODUCT DETAILS

Jotun Penguard Tie Coat 100 is a two component, polyamide cured, high molecular weight epoxy coating, specially designed as a tie coat / sealer on top of inorganic zinc silicate primers, galvanised steel and thermally sprayed zinc.

Best Uses

Jotun Penguard Tie Coat is a two component polyamide cured epoxy coating. It is suitable for structural steel and piping exposed to highly corrosive environments. Recommended for offshore environments, refineries, power plants, bridges, buildings and mining equipment. Formulated as a primer in a complete system in atmospheric environments.

Application

Jotun Penguard Tie Coat should be applied with an airless or conventional spray. The use of a brush is recommended for stripe coating or small areas. For Galvanised Steel prepare by light brush blasting using non metallic abrasive leaving a clean, rough and even pattern. For coated surfaces clean, dry and undamaged compatible coating.

TECHNICAL

Approvals

Low Flame Spread in accordance with EU Directive for Marine Equipment. Approved in accordance with parts 5 and 2 of Annex 1 of IMO 2010 FTP Code, or Parts 5 and 2 of Annex 1 of IMO FTPC when in compliance with IMO 2010 FTP Code Ch. 8
Norsok M-501 System 1 (Pre Qualified)
Norsok M-501 System 2A
Norsok M-501 System 5A (Pre Qualified)
Norsok M-501 System 8B

Technical Info

Components:	Two Part
Type:	Polyamide cured epoxy coating
Finish:	Semi Gloss
Stock Colours:	Red
Tintable:	No
VOC Content:	519.0g per litre
Volume Solids:	42%
Suitable Substrates:	Tie coat / sealer on top of inorganic zinc silicate primers, galvanised steel and thermally sprayed zinc
Application Method:	Air Spray, Airless Spray, Brush
Theoretical Coverage:	17 - 8.4m2 per litre
Wet Film Thickness (WFT):	60 - 120 microns
Dry Film Thickness (DFT):	25 - 50 microns
Induction Time:	30 mins at 23°C
Pot Life:	4 hours at 23°C
Touch Dry:	2 hours at 10°C
Overcoatable:	18 hours at 10°C
Fully Cured:	14 days at 10°C
Cleaner / Thinner:	Jotun Thinner No. 17
Shelf Life:	24 months for Part A, 48 months for Part B
Packaging:	Available in 20 Litres