Please note, this product is now discontinued. Please contact our technical team for a suitable alternative.
Sherwin Williams Acrolon C750V2 - Formerly Leighs is a isocyanate free, two pack epoxy, acrylic binder finish for exterior exposed surfaces where retention of gloss is required.
Sherwin Williams Acrolon C750V2 is best suited for when the use of isocyanate products is precluded or undesirable, such as highways applications. Normally used in conjunction with Sherwin Williams epoxy primers and undercoats.
Compatible with a wide range of Macropoxy, Dura-plate, Zinc Clad Epoxy Primers and Buildcoats. Sherwin Williams Acrolon C750V2 must be applied over epoxy materials within 4 days at 23°C to ensure satisfactory intercoat adhesion.
Ensure surfaces to be coated are clean, dry and free from all surface contamination. Recommended application method via airless spray, brush or conventional spray. Use Sherwin Williams Thinner No 5. This material should preferably be applied at temperatures in excess of 10°C. In conditions of high relative humidity, ie 80-85% good ventilation conditions are essential.
Substrate temperature shall be at least 3ºC above the dew point and always above 0°C. Topcoats not normally required but indefinitely overcoatable with itself and other high performance topcoats.
- Network Rail approved as an Isocyanate free finish
- Highways Agency No: 167
- Dry Film Thickness: 50 microns
- Theoretical Coverage: 10.6m2 per litre
- Pot Life: 12 hours at 15°C
- Available in a full range of colours
- Available in 5 and 20 Litres
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.