Sika Sikafloor 267

Sika Sikafloor®-267 is a 2-part coloured epoxy resin that provides a hard wearing, smooth gloss finish, or a slip resistant finish when broadcast with aggregates. Varying thicknesses can be achieved from 0,6 mm to 3,0 mm. It is suitable for medium to heavy wear conditions.

Best Uses

Sika Sikafloor 267 is suitable for use as a roller coating, textured coating, self-levelling coating or a seal / Top coat for slip resistant broadcast systems.

• Suitable for indoor applications due to low odour
• Multi-purpose product - can be used in many different kinds of applications
• Resistant to many chemicals
• Impermeable to liquids
• Abrasion resistant
• Slip resistant
• Can be filled with sand to produce a self-levelling coating
• High mechanical resistance

Sikafloor®-267 may only be used by experienced professionals.

Application

SUBSTRATE QUALITY / PRE-TREATMENT
Treatment of joints and cracks
Construction joints and existing static surface cracks in substrate require pre-treating before full layer application. Use Sikadur® or Sikafloor® resins. Substrates must be free of all contaminants such as dirt, oil, grease, coatings, laitance, surface treatments and loose friable material.

MIXING
Mix Part A (resin) for ~30 seconds. Add Part B (hardener) to Part A. Mix Part A + B continuously for ~3 minutes until a uniformly coloured mix is achieved.
(Optional) If necessary, gradually add between 2,5 % and 4 % by weight of flooring resin of Sika® Extender T. IMPORTANT: If product temperature is below +15 °C, gradually add ~1 % by weight of flooring resin of Sika® Thinner C. If additional materials were added, mix for a further 2 minutes until a uniform mix is achieved.

To ensure thorough mixing, pour materials into another container and mix again to achieve a smooth and uniform mix. During the final mixing stage, scrape down the sides and bottom of the mixing container with a flat or straight edge trowel at least once to ensure complete mixing.

Textured coating
Pour the mixed Product onto the substrate. Note: The consumption is specified in on the product data sheet. Apply the Product in two directions at right angles with a textured roller. Note: A seamless finish can be achieved if a wet edge is maintained during application.

Roller coating
Pour the mixed Product onto the substrate. Note: The consumption is specified in on the product data sheet. Back roll the surface in two directions at right angles with a short pile roller. Note: A seamless finish can be achieved if a wet edge is maintained during application.

Slip resistant broadcast coating
Pour the mixed Product onto the substrate. Note: The consumption is specified in on the product data sheet. Apply the Product evenly over the surface with a squeegee. Back roll the surface in two directions at right angles with a fleece roller. Note: A seamless finish can be achieved if a wet edge is maintained during application.

Self-levelling coating
Pour the mixed Product onto the substrate. Note: The consumption is specified in on the product data sheet. Apply the Product evenly over the surface with a trowel. Back roll the surface in two directions at right angles with a spike roller. Note: A seamless finish can be achieved if a wet edge is maintained during application.