Sikafloor-Comfort Adhesive is a high quality adhesive for prefabricated granular rubber on concrete and cementitious screeds and interiors where low odour properties are essential.
Sikafloor-Comfort Adhesive is a two part, total solid, low VOC, polyurethane product which is used as an adhesive coating for Sikafloor-Comfort Regupol 6015H and Sikafloor-Comfort Regupol 4580. It provides good bonding properties, is non-flammable and does not shrink after curing.
Sikafloor-Comfort Adhesive is a durable, high quality adhesive which permanently adheres prefabricated, granular rubber onto concrete and cementitious screeds. It is particularly suitable for areas such as hospitals, schools, sales areas and showrooms, entrance halls, lobbies, open-plan offices and museums. It is suitable for interior use only.
The concrete substrates and cementitious screeds must be mechanically prepared in order to remove cement laitance and achieve an open textured surface. Sikafloor-Comfort Adhesive should be thoroughly mixed, prior to application with a serrated/notched trowel.
Surface and Environment
Sikafloor-Comfort Adhesive should not be applied to surfaces where there might be a chance of rising moisture. It is also important to take care that sweat drops are not allowed to drop onto Sikafloor-Comfort Adhesive. It is recommended that head and wrist bands are worn.
Sika Sikafloor Comfort Adhesive is used within the following Sika systems:
- Sika Comfortfloor Pro PS-65
- Sika Comfortfloor Decorative Pro PS-66
See Data Sheets tab for System sheet downloadable PDF.
- Durable high quality adhesive
- Low VOC
- No shrinkage after curing
- Apply with serrated/notched trowel
- Avoid rising moisture and sweat drops
- Theoretical coverage rate: 0.45-0.90 kg per square metre (strongly dependant on sub-floor)
- Size 20 Kg
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.