Teknos Futura 40 Furniture Paint is a thixotropic urethane alkyd paint with a semi-gloss finish for wooden and primed metal surfaces internally and externally.
Teknos Futura 40 Furniture Paint is suitable for top coating of wooden and primed metal surfaces on detached furniture both indoors and outdoors. Be aware dark colours will absorb the heat more outdoors and can therefore become hotter than their equivalent lighter colours.
The surface to be painted must be clean. Wash previously painted surfaces with Rensa Super paint cleaner. Remove loose and poorly adherent paint coats. Remove any rust from the metal surfaces with a wire-brush. Sand any hard or gloss surfaces and then remove the dust particles. Fill cracks and crevices with Silora A Carpentry Filler.
Matt down the surfaces and remove the dust. Prime metal surfaces with Teknos Ferrex anti corrosive Paint. Prime unpainted wooden, chipboard and also surfaces that have been painted with alkyd, oil or acid-curing paint with Futura 3 Adhesion primer.
The paint is thixotropic and must be stirred thoroughly before use. Apply by brush, roller or spray. Suitable airless spray nozzle is 0.011 - 0.013". When applying by spray, thin the paint 5 - 15% by volume with Teknosolv 9500. When a second coat is required, it can be applied on the following day.
The surface to be painted has to be dry. During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +5°C and the relative air humidity below 80%.
|Type:||Thixotropic urethane alkyd|
|Stock Colours:||The paint is included in the Teknomix tinting system|
|Tintable:||Yes, to the Texnos Interior Paint system and RAL, BS Shades. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||The product is not included in the EU VOC directive.|
|Suitable Substrates:||Wooden and primed metal surfaces|
|Application Method:||Brush, Roller or Airless Spray|
|Theoretical Coverage:||8 - 12 m²/l Applied once onto a smooth surface|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||-|
|Touch Dry:||4 hours at 23°C|
|Overcoatable:||After 24 hours at 23°C|
|Cleaner / Thinner:||Teknosolv 1621 or Teknosolv 9500|
|Packaging:||Available in 0.9, 2.7 and 9 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.