Thermoguard Asbestos Encapsulating Coating

Thermoguard Asbestos Encapsulating Coating is recommended for use on internal wall panels, top and underside of ceiling panels, rigid internal ducts or pipework, and external wall sheets, fascia or soffits to seal asbestos products.

Best Uses

Thermoguard Asbestos Encapsulating Coating seals rigid, sound asbestos in locations within buildings which are not subject to mechanical damage, concealed or are difficult to access. Also used to seal isolated asbestos fibres remaining after primary asbestos removal has taken place. Effectively prevents the release of asbestos fibres into the atmosphere by encapsulating them. Permanently bonds residual asbestos fibres, after primary removal, to the surface to which they are attached or upon which they lay.

Each size container allows sufficient product to apply the required 2 coats to the stated areas. So, a 12m² pack should be used to apply 2 coats to 12m² and a 50m² pack should be used to apply 2 coats to 50m².

Thermoguard Asbestos Encapsulating Coating is a sealer coating based upon a unique, highly adhesive resin, highly plasticised for outstanding fexibility to withstand normal movement within a building and to the components within a building. Incorporates Flame Retardant, Smoke and flaming droplet suppressing compounds. Water based, solvent free, low odour.

Available in Matt or Eggshell. Tintable to over 4000 colours from RAL, BS & NCS colour ranges.

Application

Apply 2 coats. First coat should be thinned 10% with water and applied at 10m² per litre. Second coat should be applied undiluted at 10m² per litre. Apply by brush, roller, or low pressure HVLP spray

For ease coating inaccessible areas use extension arm on the spray unit or roller on extension pole. Ensure a continuous film has been created. Ensure surfaces are dry. Clean surfaces where practical and safe to do so. Avoid application when condensation may form.