Axalta Vitershield 178 HS Epoxy Primer / Finish
Axalta ViterShield 178 HS Epoxy Primer/Finish is a two pack epoxy, high solids, zinc phosphate primer or primer/finish for steelwork. High performance, low VOC coating to help meet SED requirements.
Best Uses
Axalta ViterShield 178 HS Epoxy Primer/Finish is a high performance, low VOC coating as a primer / finish for steelwork. Meets SED requirements. Provides a high build single coat/two coat high performance system for steelwork.
- Exceptional sag resistance
- Excellent cure speed and high build properties
- Good resistance to undercutting from damaged areas
- Overcoatable with most epoxy, acrylic or polyurethane coatings
- Use as a base coat for most thin film intumescent coatings
May be overcoated with itself or other products from the ViterShield, ViterSeal or ViterThane range.
Application
Blast clean to Sa2½ (ISO 8501-1:2007), surface profile 50-75 microns. All surfaces to be coated should be dry and cleaned as necessary to remove all oil, grease, salts, weld flux or other contamination. Where necessary, remove weld spatter and grind smooth all sharp edges and weld seams.
Apply via airless spray, conventional spray, brush or roller. Application by brush/roller will result in a reduced film thickness and is recommended only for small areas of touch up/remedial work.
If overcoating with Axalta ViterThane PLV or PLS, allow a minimum of 12 hours at 23°C when the primer has been applied to 100 microns DFT. Allow longer drying and overcoating times at higher DFT's and lower temperatures.
| Components: | Two Pack |
| Type: | Epoxy |
| Finish: | Matt |
| Stock Colours: | Grey |
| Tintable: | No |
| VOC Content: | 227 g/L |
| Volume Solids: | 70% |
| Suitable Substrates: | Steelwork |
| Application Method: | Brush, Roller, Conventional Spray or Airless Spray |
| Theoretical Coverage: | 2.5 - 9.3m2 per litre |
| Wet Film Thickness (WFT): | 107 - 400 microns |
| Dry Film Thickness (DFT): | 75 - 280 microns |
| Induction Time: | - |
| Pot Life: | 3 hours at 23°C |
| Dust Free: | 1 hour at 23°C |
| Overcoatable: | After 3 hours minimum at 23°C |
| Fully Cured: | |
| Cleaner / Thinner: | Thinner: Axalta 1031 Thinner. Cleaner: Axalta 950 Thinner |
| Shelf Life: | Minimum 12 months if stored as above in unopened containers |
| Packaging: | Available in 20 Litres |
