£7.75 delivery on orders excluding certain products & postcodes *
Bradite HD Floor and wall is ideal for interior concrete, wood or steel floors that require a tough, quick drying, hard wearing and flexible floor coating with good chemical and excellent water resistance. It can be used with a low slip additive to provide additional under foot traction.
You will need to thin the first coat on new or uncoated concrete, wood or plaster by 20-30% this will enable penetration and binding of the substrate. Application and use should always conform to the codes of practice described in BS 6150 and BS5493.
Brush and Roller – supplied ready for use. Thin, if required, with 0 - 5% water. On smooth substrates, the use of a short pile roller is advised.
Conventional Air Spraying - Thin with 10 - 20% clean water as required, tip size - 2.0mm, tip pressure 60psi (0.4MPa) approximately.
Airless Spraying - Thin with 0-15% clean water as required, tip size - 18 thou (0.46mm) approximately, tip pressure - 2100 psi (15MPa) approximately.
For further details on painting concrete, wood, plaster or other absorbent surfaces, please check the product data sheet, or call our Technical Team for advice.
Components: | Two Pack |
Type: | Water Based |
Finish: | Gloss |
Stock Colours: | Clear |
Tintable: | Yes, to most BS and RAL Colours. Please note, bespoke tints are non refundable / exchangeable |
VOC Content: | <2 g per Litre |
Volume Solids: | 57% (mixed) |
Suitable Substrates: | Concrete, steel, ceramic & terracotta tiles |
Application Method: | Brush, Roller or Spray |
Theoretical Coverage: | 13 m2/L/coat |
Wet Film Thickness (WFT): | 100 microns/coat |
Dry Film Thickness (DFT): | 57 microns/coat |
Induction Time: | - |
Pot Life: | - |
Touch Dry: | 3 hours at 20°C |
Overcoatable: | After 14 hours minimum at 20°C |
Fully Cured: | 6 days at 20°C |
Cleaner / Thinner: | Water |
Shelf Life: | 12 months minimum in original unopened containers. |
Packaging: | Available in 5 Litres for colours. Clear available in 4.2 Litres |
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.