A heavy duty, 3 part flexible binder which when broadcasted with aggregates creates a slip resistant surface.
3. Select a Qty
As low as:
£106.80
Inc VAT£128.16
As low as:
Excl. VAT:
PRODUCT DETAILS
Centrecoat ArmourCoat UltraGrip 3 is a heavy duty, 3 part flexible binder which when broadcasted with natural or synthetic aggregates creates a slip resistant profiled surface.
Best Uses
Centrecoat ArmourCoat UltraGrip 3 is suitable for car parks, ramps and pedestrian walkways when broadcasted with a compatible aggregate. Suitable aggregates are washed and dried bauxites, granites or basalts (natural or coloured).
For vehicular use, use 1 - 3mm aggregate
For pedestrian use, use 0.5 - 1.5mm aggregate
Centrecoat ArmourCoat UltraGrip 3 is suitable for use on concrete, polymer modified sand/cement screeds, suitable asphalt, wood and steel surfaces. UltraGrip 3 is hard wearing, tough and slightly flexible. It provides a seamless finish with rapid installation and minimal downtime.
Contains resin, hardener and aggregate.
Application
Centrecoat ArmourCoat UltraGrip 3 can be applied at temperatures between 5 - 30ºC. At low temperatures the material will exhibit less flow than at warmer temperatures and may be more difficult to apply at low thicknesses. The maximum substrate and atmospheric relative humidity should be 75%. The substrate and uncured floor must be kept at least 3ºC above the dew point to reduce the risk of condensation or blooming on the surface, from before priming to at least 24 hours after application. Surfaces must be completely dry before installation otherwise the material may blister and/or de-bond.
Inadequate preparation will lead to loss of adhesion and failure. Follow instructions on the data sheet prior to application.
A primer is not always necessary as Centrecoat ArmourCoat UltraGrip 3 has excellent bond strength to well prepared concrete, sand/cement screeds, suitable asphalt, timber and steel. Bond strength testing to BS EN 13892-8 should be carried out where doubt exists. Where there is a risk of excessive resin absorption into the substrate due to high surface porosity, Centrecoat ArmourCoat Multi-Use Primer should be used. Surfaces should have a relative humidity of <75%. Where the substrate relative humidity is >75%, Centrecoat Armourcoat Epoxy DPM should be used.
Follow data sheet instructions for application.
TECHNICAL
Components:
Three Pack
Type:
Epoxy Resin
Finish:
Profiled Aggregate - Available in two sizes
Stock Colours:
Natural Buff / Beige
Tintable:
No
VOC Content:
<500 g/L
Volume Solids:
Suitable Substrates:
For use on concrete, polymer modified sand/cement screeds, suitable asphalt, wood and steel surfaces.
Application Method:
Steel Float, Pin Rake or Squeegee and Spike Roller
Theoretical Coverage:
1.8 kg/m2 per mm thickness. Minimum 2 mm thickness. The applied thickness should be approximately half the nominal particle size of the broadcast aggregate.
Wet Film Thickness (WFT):
Dry Film Thickness (DFT):
Induction Time:
-
Pot Life:
10 minutes at 20°C
Light Foot Traffic:
6 hours at 20°C
Overcoatable:
Fully Cured:
24 hours at 20°C
Cleaner / Thinner:
Shelf Life:
Store off the ground in unopened packs in a dry store, under cover between 10ºC and 30ºC out of direct sunlight. Protect from frost.
Navigating through the elements of the carousel is possible using the tab key. You can skip the carousel or go straight to carousel navigation using the skip links.
Press to skip carousel
