Centrecoat Multi Surface Hygiene Coating

SKU
id24063
Non Hazardous
A hygienic high quality, water-based sheen finish. Provides proven adhesion to a variety of difficult to coat substrates.
Available in 5 Litres
From £112.70 £93.92
In stock
Only %1 left
Product Description

Centrecoat Multi Surface Hygiene Coating is a high quality, water-based sheen finish that has shown proven adhesion to a wide variety of difficult to paint substrates.

Best Uses

Centrecoat Multi Surface Hygiene Coating provides a hygienic coating suitable for use on difficult to adhere to substrates in hospitals, communal areas, vets, care homes and areas with large footfall. Suitable for internal use only.

Centrecoat Multi Surface Hygiene Coating is ideally suited for application onto substrates such as wood, carbon steel, galvanised steel (new and weathered), aluminium (including untreated), Plastisol sheeting, pre-painted surfaces, glass, ceramic tiles, GRP and certain rigid plastics.

Application

Adequate surface preparation is vital in the case of water based coating systems. All surfaces should be clean, dry and free from any form of contamination. It is strongly recommended that all surfaces to be painted are thoroughly washed and dried, and that all remaining surface contamination (such as oil /grease) be removed with a suitable degreasing solvent before preparing the surface. Failure to correctly prepare the surface could result in poor intercoat adhesion or delamination of the paint system.

Glossy finishes should be given particular attention and should be adequately abraded, where possible, to provide a good key for any subsequent coating to be applied.

Mix thoroughly before use. Where appropriate, apply a full even coat followed by a second coat after the first coat has surface dried. Can be applied by a variety of application methods including airless spray or air assisted airless spray (13-15 thou tip). NB. Not recommended for hot spray or electrostatic application.

Technical Details
Components: Single Pack
Type: Water Based
Finish: Semi Gloss Sheen
Stock Colours: 08-E-51, RAL 1014, RAL 9010, RAL 7043
Tintable: Yes, to most RAL or British Standard codes on request. Please note, bespoke tints are non refundable / exchangeable
VOC Content:  
Volume Solids: 42%
Suitable Substrates: Substrates such as wood, carbon steel, galvanised steel (new and weathered), aluminium (including
untreated), Plastisol sheeting, pre-painted surfaces, glass, ceramic tiles, GRP and certain rigid plastics.
Application Method: Airless or Air Assisted Spray
Theoretical Coverage: 12m2 per litre when applied to give a dry film thickness of 35 microns.
Wet Film Thickness (WFT):  
Dry Film Thickness (DFT): 35 microns
Induction Time: -
Pot Life: -
Touch Dry: 30 minutes at 20°C
Dry To Handle: 1 hour minimum at 20°C
Fully Cured: 7 days at 20°C
Cleaner / Thinner: Supplied ready for use, but if thinning is necessary then do not exceed 5% clean water.
All brushes, spray guns etc should be cleaned immediately after use thoroughly with water before the paint has dried on them. Solvent will be required to remove any dried on paint such as spray tips etc.
Shelf Life: 6 months dependent on temperature and conditions.
Packaging: Available in 5 Litres
Product Data Sheet (141.69 kB)
Safety Data Sheet (370.30 kB)

Related Products