Coo-Var Anti Slip Acrylic Floor Paint
Coo-Var Anti Slip Acrylic Floor Paint is a durable, water based floor paint to provide a durable and hard wearing surface with an anti-slip finish. Suitable for concrete, wood, tarmac, stone & brickwork.
Best Uses
Coo-Var Anti-Slip Acrylic Floor Paint can be used on concrete, wood, tarmac, stone, brickwork and suitably prepared metal. Ideal to provide an anti-slip finish to warehouses, ramps, parking areas, fire exits etc.
This product has been independently tested and has a PTV rating of 68 in dry conditions and 58 in wet. UK standards recommend a minimum Pendulum Test Value on floors of 36 dry, wet or contaminated. Suitable for indoor and outdoor use.
Application
All surfaces should be clean, dry, sound and free from contaminants.
Concrete - power floated, granolithic and smooth surfaces should be roughened first to provide a good "key" for the paint. This can be done mechanically by abrading or blasting, or chemically, using Coo-Var Acid Etch. These processes will have the advantage in addition to preparing the surface of also removing dirt and laitance. New concrete must be allowed to cure thoroughly which can take up to 3 months. Other surfaces have to be prepared and primed with the suitable primer for that substrate.
Existing painted surfaces - Surfaces should be cleaned, degreased and sanded to ensure an adequate "key" is produced. Remove all loose and flaking material and treat bare areas as new substrate and prepare accordingly. Apply using brush or roller.
Mix well before use. Apply direct to wood, Coo-Var All Metals Primer on Metal, Coo-Var Anti-Slip Acrylic Floor Paint thinned 5% with clean water on all other unpainted surfaces.
Certificates & Approvals
This product has been independently tested and has a PTV rating of 68 in dry conditions and 58 in wet. UK law recommends on a minimum Pendulum Test Value on floors of 36 dry, wet or contaminated. Suitable for indoor and outdoor use.
Technical Info
| Components: | Single Pack |
| Type: | Acrylic |
| Finish: | Matt |
| Stock Colours: | Tile Red, Grey, Light Grey, Yellow, Green, Black and White |
| Tintable: | No |
| VOC Content: | 41 g/Litre |
| Volume Solids: | 34 to 36% |
| Suitable Substrates: | Concrete, wood, tarmac, stone, brickwork and suitably prepared metal |
| Application Method: | Brush or Roller |
| Theoretical Coverage: | 5 to 9 m2 per litre @ 35 microns DFT |
| Wet Film Thickness (WFT): | 100 to 110 microns |
| Dry Film Thickness (DFT): | 35 to 40 microns |
| Induction Time: | - |
| Touch Dry: | 1 hour at 20°C |
| Hard Dry: | 4 hours at 20°C |
| Overcoatable: | After 6 hours minimum at 20°C |
| Fully Cured: | 5 to 7 days at 20°C |
| Cleaner / Thinner: | Thin with Clean Water (Max vol 10%) |
| Shelf Life: | - |
| Packaging: | Available in 2.5 and 5 Litres |
