Hempel Hempathane HS 55613 is formulated as a VOC-compliant, high-build finishing coat for protection of structural steel in a corrosive environment. May be specified as a one coat "Direct To Metal" system in environments classified as C2 and C3.
Prepare according to specification. Apply only on a dry and clean surface with a temperature above the dew point to avoid condensation. Minimum temperature for curing is: -10°C/14°F At the freezing point and below be aware of the risk of ice on the surface, which will hinder adhesion. The film formation may be adversely affected by light rain, high humidity and/or condensation during application and the following interval after application: 8 hours, 20°C/68°F In confined spaces provide adequate ventilation during application and drying.
When specified as a one coat “Direct to Metal”-system, follow “Good Painting Practice” and apply stripe coating before the spray application on areas difficult to cover properly by spray application. Even small traces of water in the mixed paint will reduce the pot life and result in film defects.
|Stock Colours:||11150 Grey|
|Tintable:||Yes, call our Sales Team to check certain shades. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||384 g/L|
|Suitable Substrates:||For protection of structual steel|
|Application Method:||Airless Spray or Brush|
|Theoretical Coverage:||5.7 m2 per litre per 100 microns|
|Wet Film Thickness (WFT):||175 microns|
|Dry Film Thickness (DFT):||100 microns|
|Pot Life:||2 hours at 20°C|
|Surface Dry:||45 minutes at 20°C|
|Overcoatable:||Dependant on Specification|
|Fully Cured:||7 days at 20°C|
|Cleaner / Thinner:||Hempel Thinner 08080|
|Shelf Life:||3 years for BASE and 2 years (25°C/77°F) for CURING AGENT from time of production|
|Packaging:||Available in 5 and 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.
A high performance fast drying acrylic urethane semi-gloss finish for use where long term exterior colour retention is required. Highways Agency Item ...