International Ceilcote 380 Primer

UN1263 (Class: 3, Pk Grp: III)
A primer for vinyl ester schemes over both steel and concrete.
Available in 15 Litres
£664.48 £553.73
In stock
Product Description

International Ceilcote 380 Primer provides excellent bonding and adhesion for various polyester and vinyl ester linings, coatings and flooring systems, as well as for Ceilcote Hybrid Polymer systems. Uses Ceilcote No.2 Hardener.

Best Uses

Ceilcote 380 is intended for use as a primer for vinyl ester schemes over concrete and steel.


The recommended application is by airless spray or short nap roller, however application by brush is also suitable.

All surfaces to be coated should be clean, dry and free from contamination. Prior to paint application, all steel surfaces should be assessed and treated in accordance with ISO 8504:2000. Oil or grease should be removed in accordance with SSPC-SP1 Solvent Cleaning.

Steel Substrates
For immersion service or service in humid conditions or elevated temperatures, this product should be applied to surfaces which have been prepared by abrasive blast cleaning to Sa3 (ISO 8501-1:2007), SSPC SP5 or NACE #1. For dry environments, abrasive blast cleaning to Sa2½ (ISO 8501-1:2007), SSPC SP10 or NACE #2 will be suitable. A minimum surface profile of 75 microns (3 mils) is required.

Ceilcote 380 Primer must be applied before oxidation of the steel occurs. If oxidation does occur, the entire oxidised area should be re-blasted to the standard specified above. Any surface defects that are revealed by the blast cleaning process should be ground, filled or treated in the appropriate manner.

Concrete Substrates
Concrete should be well cured prior to application of the flooring, lining or coating system. Refer to the Concrete Surface Preparation Guidelines for more information.

Technical Details
Components: Two Component
Type: Solvent Free
Finish: n/a
Stock Colours: Translucent purple
Tintable: No
VOC Content: 361 g/lt
Volume Solids: 75%
Suitable Substrates: Steel and Concrete
Application Method: Airless Spray, Roller, Brush, Trowel
Theoretical Coverage: 10 m²/litre at 75µm d.f.t
Wet Film Thickness (WFT): 67-167µm
Dry Film Thickness (DFT): 50-125µm
Induction Time: -
Pot Life: 30 minutes at 25°C
Touch Dry: 45 minutes at 25°C
Overcoatable: Min 2 hours to max 1 week at 25°C
Hard Dry: 90 minutes at 25°C
Cleaner / Thinner: Do not thin. Clean all equipment immediately after use with T-410 Solvent
Shelf Life: 6 months from date of production unopened 
Packaging: Available in 15 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Related Products