Jotun Muki Z 2001
Jotun Muki Z 2001 is a two component inorganic low zinc moisture curing zinc ethyl silicate coating. Formulated as a shop primer designed for very high welding and cutting speed, giving reduced weld porosity and back burning.
Best Uses
Jotun Muki Z 2001 is fast drying and has good abrasion resistance making it suitable for stacking shortly after application. Can be used as temporary primer in a new construction phase or as primer in a complete coating system in atmospheric and immersed environments. Suitable for properly prepared carbon steel substrates and recommended to be applied in an automated shop priming line. Compatible with advanced welding technologies including MIG, MAG and GFCAW.
Suitable for structural steel and piping to be exposed to corrosive environments up to very high and immersed. Recommended for offshore environments, refineries, power plants, bridges, buildings, mining equipment and general structural steel.
Application
Prepare carbon steel to Sa 2 1/2. Apply via air spray or airless spray. Use a brush for touch up purposes. For fast evaporation, use Jotun Thinner No.4. For slow evaporation, use Jotun Thinner No. 25.
Approvals
- Approved for PSPC for Water Ballast Tanks according to IMO Res. MSC 215(82)
- Welding approved according to DVS-guideline 0501
- Type approved as shop primer by DNV
- Type approved shop primer according to PSPC IMO Res. MSC 82/W
- Type approved shop primer for Germanischer Lloyd
- Health approved for use as shop primer by FORCE institute
Notes
Heat resistant in dry atmospheric environments to 400°C continuously.
Technical
| Components: | Two Part |
| Type: | Inorganic low zinc moisture curing zinc ethyl silicate coating |
| Finish: | Matt |
| Stock Colours: | Green, Grey and Red |
| Tintable: | No |
| VOC Content: | 628.0g per Litre |
| Volume Solids: | 28% |
| Suitable Substrates: | Properly prepared carbon steel substrates |
| Application Method: | Air Spray or Airless Spray, Brush for Touch Up |
| Theoretical Coverage: | 18.7 - 14 m2 |
| Wet Film Thickness (WFT): | 55 - 70 microns |
| Dry Film Thickness (DFT): | 15 - 20 microns |
| Induction Time: | - |
| Pot Life: | 24 hours |
| Touch Dry: | 1 minute at 23°C |
| Overcoatable: | 1 day at 23°C |
| Fully Cured: | 1 day at 23°C |
| Cleaner / Thinner: | Jotun Thinner No. 4 for fast evaporation or Jotun Thinner No. 25 for slow evaporation |
| Shelf Life: | Part A: 6 months, Part B: 24 months |
| Packaging: | Available in 16.75 Litres |
