Sherwin Williams Macropoxy M330 - Formerly Leighs Epigrip is a 2 pack epoxy tie sealercoat for use over zinc silicate and other types of zinc rich primers.
Macropoxy M330 is best uses either as a blast primer for use over stainless steel or as a sealercoat for use over zinc silicate and other types of zinc rich primers.
Recommended primers and top coats: Zinc Clad J984 Zinc Rich Primer and Zinc Clad II EU. Ensure surfaces to be coated are clean, dry and free from all surface contamination. Indefinitely overcoatable with epoxy systems provided the surfaces to be coated have been suitably cleaned. Where a high degree of gloss and colour retention is required, overcoat with Acrolon C137V2, Acrolon C237 within 7 days at a minimum dft of 50 microns or in the case of Acrolon C750V2 overcoat within 4 days. These overcoating times refer to achievement of optimum adhesion at 23°C and will vary with temperature. Recommended application using airless spray using thinner no5.
- Drying Time: 10 minutes at 23°C to touch, 4 hours at 23°C to recoat
- Pot Life: 8 hours at 23°C
- Dry Film Thickness: 25 microns
- Theoretical Coverage: 18.8m2 per litre
- Available in red oxide
- Available in 5 Litres
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.