Mapei Mapeproof 1K Turbo is a single component, solvent free, moisture curing and rapid drying polyurethane surface membrane with very low emission of VOC's, for use for waterproofing cementitious screeds that are not subject to rising damp.
Mapeproof 1K Turbo has been developed for use for waterproofing cementitious screeds, that are not subject to rising damp, but have a residual humidity content higher than the British Standards 75% RH (BS8203) for laying resilient and wood flooring.
Mapeproof 1K Turbo is suitable for consolidating cementitious floor screeds which are mechanically weak, as well as a waterproofing treatment before laying wooden flooring, to prevent a failure due to excessive residual humidity in the cementitious floor screed.
Mapeproof 1K Turbo is a single-component polyurethane primer which hardens due to the humidity present in the surrounding air and in the screed.
Mapeproof 1K Turbo offers a fast return to service to light foot traffic.
Mapeproof 1K Turbo quickly becomes touch dry so that parquet wood flooring can be laid after a very short time (after approximately 2 hours in normal conditions of temperature and humidity).
Mapeproof 1K Turbo does not contain solvents, it is also odourless and non-flammable.
Mapeproof 1K Turbo has a very low emission level of VOC's (volatile organic compounds) (EMICODE EC1 R). Due to the total absence of solvents and odour, Mapeproof 1K Turbo may also be used on sites which are located close to inhabited areas (such as flats, schools, offices, etc.).
After application and rapid curing of the resin, the substrate treated with Mapeproof 1K Turbo becomes more consistent, harder and is more abrasion resistant.
- EMICODE EC1 R offers extremely low emission level
- Customs class 3208 90 91
|Dry solids content (%):||100|
|Suitable Substrates:||Cementitious screeds|
|Maximum residual humidity permitted||5%, measured with carbide hygrometer (for screeds thicknesses of approx. 6 cm)|
|Brookfield viscosity (at +23°C) (mPa·s):||300 (# 1 - 10 rpm)|
|Application temperature range:||from +5°C to +35°C|
|Loss of stickiness:||After 30-40 minutes|
|Set to light foot traffic:||60 minutes|
|Final hardening time:||After 2 hours|
|Waiting time between each coat:||Minimum 40 minutes, max. 2 hours|
|Waiting time before laying directly with adhesive:||Minimum 2 hours, maximum 24 hours|
|Shelf Life:||12 months in its original well-sealed container stored under normal conditions|
|Packaging:||Available in 10kg drums|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.