PPG PhenGuard 965 is a two component, high build, amine adduct-cured novolac phenolic epoxy coating for offshore, marine and chemical / petrochemical sectors.
PPG PhenGuard is formulated as a chemical resistant tank lining. For detailed information on resistance and resistance notes please contact us.
- Excellent resistance to a wide range of organic acids, alcohols, fats (regardless of free fatty acid content) and solvents
- Maximum cargo flexibility
- Low cargo absorption
- Easy to clean
- Good resistance to hot water
- Can be applied and cures at temperatures down to 5°C (41°F)
- Good application properties, resulting in a smooth surface
Steel should be blast cleaned in situ to at least ISO 2 1/2 with a blasting profile of between 50-100 microns. Steel mist be free from rust, scale, shop primer and any other contamination. Please allow for tins induction time of 10 minutes at 15°C.
Minimum curing time of PhenGuard 965 system before transport of cargoes is 3 months according to data sheet. For transport of methanol and vinyl acetate monomer, a hot cure is required which cannot be substituted by a service period of 3 months with non aggressive cargoes. Adequate ventilation must be maintained during application and curing. When used as a primer under solvent free tank linings, the DFT must be limited to a maximum of 100 microns (4 mils).
PPG PhenGuard 965 is used within the following Sika systems:
- PPG 3329 System - PhenGuard 965 Tank Coating System
See Data Sheets tab for System sheet downloadable PDF.
|Stock Colours:||Off White, Pink, Grey|
|VOC Content:||329.0 g/l|
|Application Method:||Air or Airless Spray|
6.8m2 per litre for 100 microns
5.4m2 per litre for 125 microns
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):||500 - 1500μm|
|Pot Life:||2 hours at 20°C|
|Touch Dry:||18 hours at 1500 microns at 20°C|
|Recoatable:||8 hours - 14 days at 20°C|
|Full Cure||3 days at 20°C|
|Cleaner / Thinner:||Clean with PPG Thinner 91-92|
|Shelf Life:||At least 12 months when stored cool and dry|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.