PPG Phenguard Subsea 610 is a two component, high build, amine adduct-cured novolac phenolic epoxy primer for subsequent coats of PPG Phenguard Subsea 780.
PPG Phenguard Subsea 610 is a subsea primer for the 2-coat system with PPG Phenguard Subsea 780.
- Excellent resistance to high temperature cathodic protection
- Meets the requirements of Norsok M-501 rev. 6, system 7C (180°C / 356°F)
- Excellent resistance to seawater immersion
- Very good corrosion control
- Good application properties
Steel should be blast cleaned ion situ to at least ISO Sa2 1/2 with a blasting profile of between 50 - 100 microns. Steel must be free from rust, scale, shop primer and any other contamination. The temperature of the paint should preferably be above 15C otherwise extra thinner may be required to obtain application viscosity.
PPG Phenguard Subsea 610 is used within the following PPG systems:
- PPG P532 System - Systems For Applicatio and Repair Subsea
See Data Sheets tab for System sheet downloadable PDF.
|Type:||High build, amine adduct cured novolac pheonlic epoxy primer|
|Stock Colours:||Reddish Grey|
|VOC Content:||315.0g per litre|
|Application Method:||Air Spray, Airless Spray, Brush or Roller|
|Theoretical Coverage:||3.8m2 per litre for 175 microns|
|Wet Film Thickness (WFT):||150 - 500 microns|
|Dry Film Thickness (DFT):||175 microns|
|Induction Time:||15 mins at 20°C|
|Pot Life:||4 hours at 20°C|
|Overcoatable:||Between 3 hours and 21 days at 20°C|
|Fully Cured:||3 days at 20°C|
|Cleaner / Thinner:||PPG Thinners 91-92|
|Shelf Life:||24 months|
|Packaging:||Available in 4 and 20 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.