Remmers Epoxy WHG Color AS
Remmers Epoxy WHG Color AS is an electro conductive, chemically resistant, crack bridging coating for use within electro static conductive floor systems by Remmers.
Best Uses
Remmers Epoxy WHG Color AS is an anti static floor coating with crack bridging abilities. Being highly resistant to chemicals, this product is also suitable for hand pallet truck and fortlift truck use in warehouse environments. Remmers Epoxy WHF Color AS also benefits from being fire resistant.
Possible system products:
- Remmers WHG TX
- Remmers Epoxy GL 100
- Remmers Epoxy Conductive
Application
The substrate must be firm, dimensionally stable, capable of bearing loads and free of loose constituents, dust, oil, grease, rubber marks and other substances that could interfere with adhesion. The adhesive pull strength of the surface after priming must be at least 1.5 N/mm² on average (smallest single value min. 1.0 N/mm²), compressive strength at least 25 N/mm². Suitable Remmers epoxy primers, epoxy scratch coats or epoxy mortars must always be used.
For works within the framework of the general building inspectorate approval, the substrates must correspond to the requirements of the approval and the system products mentioned therein must be used.
Before the application of the product a smooth surface must be produced, e.g. with a scratch coat. Refer to the current Technical Data Sheet for detailed information on the single products. Epoxy Conductive must be applied according to the current Technical Data Sheet as transverse conducting layer.
Pour the material onto the prepared substrate and then distribute with suitable means, e.g. a toothed trowel or toothed spreader. Afterwards roll over with a (metal) spiked roller.
Systems
- Remmers 356WHG - Epoxy Conductive with Excellent Chemical Resistance System (1.5 - 2mm)
See technical tab for downloadable System Sheets.
Technical Info
| Components: | Two Pack |
| Type: | Epoxy |
| Finish: | |
| Stock Colours: | Pebble Grey 1431 and Light Grey 1432 |
| Tintable: | Yes, on orders over 100 Kg. Please note, bespoke tints are non refundable / exchangeable |
| VOC Content: | <500 g/L |
| Volume Solids: | |
| Suitable Substrates: | Wihin Remmers electro static floor systems |
| Application Method: | Toothed trowel, notched spreader, spiked roller (metal), rubber scraper, epoxy roller |
| Theoretical Coverage: | Dependant on system |
| Wet Film Thickness (WFT): | |
| Dry Film Thickness (DFT): | |
| Induction Time: | - |
| Pot Life: | 45 minutes at 20°C |
| Foot Traffic: | 16 hours at 20°C |
| Overcoatable: | Waiting times between coats should be at least 12 hours and max. 48 hours at 20°C. If conditions on site require longer waiting times, the surface must be slightly sanded (until it turns white) before the following application. |
| Fully Cured: | 7 days at 20°C |
| Cleaner / Thinner: | Clean tools, equipment and splashed material immediately while fresh with Remmers V 101 Thinner. Take suitable protective and waste disposal measures when cleaning. |
| Shelf Life: | If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months. |
| Packaging: | Available in 10 and 25 Kg |
RELATED PRODUCTS
