Teamac High Performance Marine Primer

For use below the waterline and harsh marine environments.

Available in 5 Litres

* These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.

2. Size

3. Select a Qty

As low as:

£129.62

Inc VAT £155.54

PRODUCT DETAILS

Teamac High Performance Marine Primer is a two-pack epoxy zinc phosphate coating that can extend the lifespan of your boat. It is suitable for yachts, power boats, dinghies, narrow boats, cruisers, commercial vessels and many other marine applications.

Best Uses

Teamac High Performance Marine Primer can be applied to suitably prepared wood, GRP, steel and aluminium. It is used for application to blast cleaned and other suitably prepared steel surfaces. It is not suitable for use as a weld through blast primer.

Highest level of corrosion resistance
Designed for use below the waterline and harsh marine environments
Perfect For Wood, GRP, Steel & Aluminium
Can be used with Teamac Marine Anti-Fouling & Topcoats.
Can be applied over 2 pack zinc phosphate blast primers which are free from contamination

Provided the steel has been cleaned effectively, an outstanding bond is formed between primer and metal.

Application

Prior to application you must ensure all surfaces are clean, dry and free from grease, oil and any other contaminates. Bare steel needs to be free from dust, rust and scale. Blast cleaning to SA 2½ is recommended. If blast cleaning is impractical, mechanical cleaning should be employed, as hand cleaning does not clean the steel to the required degree. Any oil or grease should be removed with solvent before de-rusting. Where blast cleaning is carried out after assembly, special attention must be paid to edges, corners, nuts, bolts welds, etc. Welds should, if necessary, be ground and all weld spatter etc. must be removed.

TECHNICAL

Components:	Two Part
Type:	Primer
Finish:	Eggshell
Stock Colours:	Grey or Red
Tintable:	No.
VOC Content:	Less than 500 g/litre
Volume Solids:	52.5
Suitable Substrates:	Metal, Wood, GRP, Steel & Aluminium
Application Method:	Brush or Airless Spray
Theoretical Coverage:	12 m2 per litre at 44 microns DFT
Wet Film Thickness (WFT):	85 to 190 microns
Dry Film Thickness (DFT):	44 to 100 microns
Induction Time:	-
Pot Life:	4 hours at 20°C
Initial Cure::	1.5 to 2 hours at 20°C
Overcoatable:	After minimum 2 to 4 hours at 20°C
Fully Cured:	3-5 days at 20°C
Cleaner / Thinner:	Do Not Thin. Clean tools with Epoxy Cleaners 39
Shelf Life:	-
Packaging:	Available in 5 Litres