Tensid Cladex HD is a concentrated heavy duty alkaline cleaner, for cleaning heavily soiled plastic type material. It also removes chalking from painted surfaces. In addition it can be used for surface preparation prior to applying the Cladex Revive or Cladex Restore System.
Tensid Cladex HD is ideal for cleaning heavily soiled plastic type material and contemporary cladding material such as anodised aluminium and other metal surfaces. It can also be used for surface preparation prior to applying the Cladex Revive or Cladex Restore system.
Always test each type of surface to ensure suitability and desired results. For initial cleaning, depending upon level of soiling, maximum dilution 1:5. For maintenance Cleaning maximum dilution 1:20. Apply the solution with a sponge or low pressure sprayer. Leave for a few minutes, some agitation may be required. Do not allow the product to dry on the surface. Rinse thoroughly with clean water. Note: For lighter soiled surfaces use Cladex LD.
Minimum air temperature 5°C
Maximum relative humidity 100%
Minimum surface temperature 5°C
Maximum surface temperature 30°C
|Type:||Heavy duty cladding cleaner|
|Finish:||Appearance is a red transparent liquid|
|Suitable Substrates:||Heavily soiled plastic, contemporary cladding and anodised aluminium|
|Application Method:||Sponge or low pressure sprayer|
|Theoretical Coverage:||Approximately 20m2 per litre|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||-|
|Fully Cured:||Leave product on for a few minutes but do not allow to dry on the surface|
|Cleaner / Thinner:||-|
|Shelf Life:||12 months in a tightly sealed unopened container|
|Packaging:||Available in 10 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.