Tikkurila Temadur 90

Tikkurila Temadur 90 is a two-component, high gloss polyurethane paint, formulated for various metal structures such as heavy machinery, haulage equipment, interior wood such as kitchens, tank exteriors, steel structures and more.

Best Uses

Tikkurila Temadur 90 is formulated to form a durable, easy-to-clean and non-chalking topcoat with outstanding gloss and colour retention. The paint has an almost unlimited range of colours, including metallic effects.

Providing outstanding resistance to weathering and abrasion, Tikkurila Temadur 90 is an idealsolution for original equipment manufacturing, such as agricultural machinery and haulage equipment. It is also suitable for storage tank exteriors, steel framework and other steel structures, machinery and equipment.

Alternatively, Temadur 90 can be used for interior wooden surfaces, e.g. metallic shades kitchen doors.

Recommended to be used as a glossy decorative finishing coat for epoxy systems on a variety of substrates such as steel, aluminium, concrete etc. exposed to severe weathering and/or chemical stress.

Application

Preparation

Primed surfaces: Oil, grease, salt and dirt are removed from the surface by appropriate means. Repair any damage to the primer coat. Note the overcoating time of primer. (ISO 12944-4)
Concrete surfaces: See the respective data sheets of concrete systems.

Recommended Primers

• Temacoat GPL-S Primer, Temacoat GF Primer, Temacoat GPL-S MIO, Temacoat RM 40, Temacoat SPA Primer, Temacoat SPA 50, Temamastic PM 100, Temabond ST 200, Temabond ST 300, Temadur 10, Temadur 20, Temaprime GF, Temafloor PU, Temafloor PU-UV, Temafloor P300.
• Concrete surfaces: Temafloor PU, Temafloor PU-UV or Temafloor P300. For more information in the respective data sheets.

Recommended Topcoats

• Temadur 90, Temadur Clear

Application

Ambient air, surface and paint should not fall below +5ºC during application and drying. Relative humidity of the air should not exceed 80% during application and drying. The surface temperature of steel should remain at least 3°C above the dew point. Good ventilation and sufficient air movement is required in confined areas during application and drying.

In order to obtain an even, non-porous finish, spray a misty coat: first a thin layer, then let the solvents evaporate for 5–30 minutes and then apply the full coat. For airless spraying, the product is thinned depending on the temperature of the components (base, hardener, thinner) approximately 10–22% to the viscosity 20–25s (DIN4). Recommended nozzle tip is 0.011 – 0.013 inches and pressure 120–160 bar. Spray angle shall be chosen according to the shape of the object. For conventional spraying, the product is thinned to the viscosity 20–25s (DIN4). Recommended nozzle tip is 1.2–1.8 mm and pressure 3–4 bar.

For brush application product should be thinned according to the circumstances.