Centrecoat Thermoplastic Primer

SKU
id23743
UN1866 (Class:3, Pk Grp: III)
A single pack, solvent borne, acrylic resin based, thermoplastic primer for concrete and block paving.
Available in 2.5 Litres
£38.40 £32.00
In stock
Product Description

Centrecoat Thermoplastic Primer is a single pack, solvent borne, acrylic resin based, thermoplastic primer for concrete and block paving.

Best Uses

When applied onto old concrete or blocks, Centrecoat Thermoplastic Primer penetrates into the pore structure thereby sealing and dust proofing the surface, to aid the adhesion of thermoplastic line markings and logos.

  • Easily applied by brush, roller or spray
  • Single pack – ready to use
  • Good chemical and abrasion resistance
  • Seals and dust-proofs the surface
  • Resistant to ultra violet radiation
  • Provides easily cleanable floor surface
  • Internal and external use

When applied to freshly placed concrete, Centrecoat Thermoplastic Primer functions as a curing membrane, reducing any tendency towards drying shrinkage cracks. At the same time the surface becomes sealed against the ingress of oils and many aqueous chemicals, and a harder wearing floor is produced.

This product can also be used as a curing/sealing treatment to new concrete, and as a sealing/dust-proofing treatment to old concrete and blocks to provide a sealed and dust-proof surface with resistance to the ingress of oil, petrol and chemical spillages.

Application

On old concrete, apply a coat of Centrecoat Thermoplastic Primer by brush, roller, squeegee or spray at a nominal rate of 8-9m²/litre.

On new concrete apply Centrecoat Thermoplastic Primer by spray at 5m²/litre. Apply evenly and avoid the formation of puddles of excess material on the surface. On block paving, ensure material is applied to fully seal the surface. Coverage is dependent on the porosity of the block.

Technical Details
Components: Single Pack
Type: Solvent borne, acrylic resin base
Finish:  
Stock Colours: Pale straw coloured liquid
Tintable: No
VOC Content:  
Volume Solids:  
Suitable Substrates: Concrete and blocks
Application Method: Brush, Roller or Spray
Theoretical Coverage: See data sheet
Wet Film Thickness (WFT):  
Dry Film Thickness (DFT):  
Induction Time: -
Pot Life: 25 - 30 minutes at 20°C
Tack Free Time: 2 - 4 hours at 20°C
Hard Dry Time: 24 hours at 23°C
Fully Cured: -
Cleaner / Thinner: Centrecoat Tool Cleaner
Shelf Life: Minimum of 12 months shelf life when stored in original, unopened containers in accordance with manufacturer’s instructions.
Packaging: Available in 2.5 Litres

The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.

Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.

Recommended products to use