Macropoxy M922M is best used as 1 or 2 coat maintenance system for short possessions on Network Rail applications. Suitable for anti corrosive protection of blast cleaned steel compatible with cathodic protection. Formulated for high build application by brush, allowing applicators to achieve full specified thickness in a single coat even on sharp edges and difficult access areas. Also recommended for application onto hand or mechanically prepared surfaces and or damp gingered blasted surfaces giving excellent wetting and adhesion characteristics. Suitable for application onto hot substrates up to 100°C
Manually prepare surfaces to a minimum standard of St3 BS EN ISO 8501-1:2007 at time of coating. Ensure surfaces are clean and free from all surface contamination. Macropoxy M922M can be applied by airless spray or brush. Recommended Thinner Sherwin Williams No9. It is possible to apply Macropoxy M922M onto a damp substrate ie no running or pooled water by brush application. Ensure that the paint fully displaces any water on the substrate. Indefinitely self overcoatable provided the existing coating is suitably cleaned. Overcoating should occur within 14 days. Compatible Overcoats: Acrolon C137V2, Acrolon C237, Acrolon 1850 and Acrolon 7300
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.
A high performance, fast drying, acrylic urethane exterior gloss with good colour retention. N9, M24, M34 and Item No.168. approved.
Used as a temporary protective coating for steel surfaces prepared by abrasive blast cleaning.
A two pack isocyanate free finish based on an acrylic epoxy binder system. NORSOK M501 Rev 6 System 1.
A high performance fast drying acrylic urethane sheen finish for use where long term exterior colour retention characteristics are requ...
A 2 pack zinc phosphate epoxy wet blast primer for application to surfaces which have been prepared by wet abrasive blasting.