Mapei Dursilite Matt is a internal transpirant, high opacity, washable water-based paint for internal use.
With an attractive velvety uniform matt finish, Dursilite Matt paint has a low dirt retention capacity ideal for all types of new, old and painted internal surfaces. Ideal for well cured or cementitious, lime or gypsum render, as long as they are regular, well bonded and have no flaky or crumbly areas.
Dursilite is a modified vinyl resin based washable matt paint in water dispersion with selected charges with good covering properties and white point for internal walls. Dursilite bonds perfectly to all types of masonry, render, smoothing and levelling compounds as well as old paintwork as long as it is not crumbling and is well attached.
Do not to apply if the temperature is lower than +5°C. Do not apply if the level of humidity is higher than 85%. Do not apply to external surfaces or damp substrates that are not fully cured.
Surfaces must be well cured, sound and dry and perfectly clean, ensuring all traces of oil and grease from all parts are removed. Designed to use Mapei Malech primer prior to use. If a bright colour such as yellow, green or bright red is required, ensure to use Dursilite Base Coat.
Dilute the product with 15 -20% of water making sure it is thoroughly blended. Please note, add 2 - 2.5 litres of fresh, clean water per 20kg tub. Then thoroughly mix with an electric mix before use
Dursilite should be applied 12-24 hours after a base coat if applied. Can be applied using a roller, brush or spray - please refer to datasheets prior to use.
|Tintable:||Yes, to most RAL or British Standard codes. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||< 10 g/L|
|Suitable Substrates:||For protecting and decorating cementitious, lime or gypsum-based substrates.|
|Application Method:||Brush, Roller or Spray|
|Theoretical Coverage:||Consumption is heavily influenced by the absorption and roughness of the substrate, by the colour applied and according to the
application technique used. Under normal conditions, consumption is generally 0.3 - 0.4 Kg per m2 (for two coats of the product)
|Wet Film Thickness (WFT):|
|Dry Film Thickness (DFT):|
|Dilution Ratio:||15-20% of water|
|Overcoatable:||6-12 hours at 20°C, depending on surrounding temperature and humidity conditions; the previous coat must always be completely dry|
|Cleaner / Thinner:||Water|
|Shelf Life:||24 months if stored in a dry place away from sources of heat at a temperature of between +5°C and +30°C. Protect from frost.|
|Packaging:||Available in 5 and 20 Kg|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.