NORSOK Approved Paints

Carboline Carboguard 891 VOC
An ultra high solids epoxy that is designed as a liner for potable water. FDA approved.

From £675.00 £562.50
Jotun Jotamastic 87 GF Wintergrade
A two component protective coating for use in high traffic, atmospheric and immersed environments.

From £356.18 £296.82
Jotun Marathon 550
A 2 pack structural steel and piping coating that will continue to cure while immersed.

From £351.36 £292.80
Jotun Jotamastic 87 GF
A two component protective coating for use in high traffic, atmospheric and immersed environments.

From £314.28 £261.90
Jotun Jotamastic 87 Aluminium WG
Low temperature curing, two component coating, providing protection in atmospheric and immersed environments.

From £83.80 £69.83
Jotun Jota Armour Standard
A 3 part, high solids, surface tolerant, abrasion resistant anti-corrosive epoxy coating with a selected blend of fused aluminium oxide.

From £190.84 £159.03
Jotun Tankguard HB Classic Formerly Tankguard HB
A 2 part polyamine cured epoxy coating with good chemical resistance formulated for use as a primer, mid coat or finish coat.

From £344.88 £287.40
Jotun Jotamastic 80 Aluminium
A two component epoxy coating for carbon and shop primed steel and coated surfaces. Can be applied at sub zero surface temperatures.

From £57.76 £48.13

System 1 (pre-qualified)	Carbon steel with maximum operating temperature < 120°C (248°F) Structural steel Exteriors of equipment, vessels, piping and valves (not insulated)
System 2	Carbon steel surfaces exposed to operating temperatures > 120°C (248°F)
System 3A-3G (System 3B pre-qualified)	Internal surface of carbon steel tanks
System 4 (pre-qualified)	Walkways, escape routes and lay down areas
System 5A (pre-qualified)	Epoxy-based fire protection
System 5B (pre-qualified)	Cement-based fire protection
System 6A	Uninsulated stainless steel when painting is required. Aluminum when painting is required
System 6B	Hot-dipped, galvanized steel when painting is required
System 6C	Insulated stainless steel piping and vessels at temperatures < 150°C (302°F)
System 7A (pre-qualified)	Carbon and stainless steel in the splash zone
System 7B (pre-qualified)	Submerged carbon and stainless steel ≤ 50°C (122°F)
System 7C (pre-qualified)	Submerged carbon and stainless steel > 50°C (122°F)
System 8a	Structural carbon steel with maximum operating temperature ≤ 80°C (176°F) in internal and fully dry and ventilated areas
System 8b	Structural carbon steel with maximum operating temperature ≤ 80°C (176°F) in fully dry and ventilated areas
System 9	Bulk-supplied carbon steel valves with maximum operating temperature up to 150°C (302°F)