Coo-Var Power Floated Floor Primer
Coo-Var Power Floated Floor Primer is a water based two pack epoxy primer designed for application to power floated floors.
Best Uses
Coo-Var Power Floated Floor Primer is used to assist the adhesion of Profloor and Profloor Plus floor paints to power floated floors. It removes the need for shot blasting or grinding on clean, laitance free, power floated floors. It is ideal for areas where organic solvents are banned and has a low odour.
Application
The primer should be diluted with 10% water for application. Floors must be completely laitance free, if for any reason residual laitance is present then this should be removed by using Coo-Var Acid Etch first.
New concrete must be allowed to cure thoroughly which can take up to 3 months. Other surfaces have to be prepared and primed with the suitable primer for that substrate. If in doubt please contact Promain Technical Services for advice.
Features
- Assists adhesion of the topcoat
- Low Odour
- Fast Drying
- Recommended for use under Profloor or Profloor Plus
Technical Info
| Components: | Two Pack |
| Type: | Epoxy Primer |
| Stock Colours: | Opaque when wet, dries clear |
| Tintable: | No |
| Suitable Substrates: | Concrete |
| Cleaner / Thinner: | Thin with Clean Water (Max Vol 500ml). Clean tools with water |
| Packaging: | Available in 5 Kg |
| VOC Content: | Below 10g / litre |
| Application Method: | Brush or Short Pile Roller |
| Theoretical Coverage: | 35 to 50 m2 per 5 Kg pack @ 45 microns D.F. |
| Finish: | Semi Gloss |
| Fully Cured: | 5 to 7 days at 20°C |
| Volume Solids: | 46% |
| Pot Life: | 1.5 to 2 hours at 20°C |
| Overcoatable: | After minimum of 16 hours at 20°C |
| Wet Film Thickness (WFT): | 100 microns |
| Dry Film Thickness (DFT): | 45 microns |
| Initial Cure: | 2 to 3 hours at 20°C |
