*Jotun Tankguard Plus
Please note, this product is now discontinued. Contact our technical team for a suitable alternative.
Jotun Tankguard Plus is a two component novolac epoxy tank coating. It is a specially designed tank lining with excellent chemical resistance, and is cured for service in only five days. Tankguard Plus is specially well suited for all grades of crude oils.
Best Uses
Jotun Tankguard Plus is specially designed as an internal lining for offshore, onshore and buried tanks and pipes such as chemical storage, waste water, grey water, process water, concrete bund, fire service lines and drilling mud tanks. This coating has very good resistance to high temperature products.
Jotun Tankguard Plus a two component polyamine cured phenolic / novolac epoxy coating. It has a high resistance to most sour crude oils and a wide range of chemicals and solvents. It has outstanding chemical resistance to crude oil at temperatures up to 160 °C. Can be used as primer, mid-coat or finish coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates.
- Sour crude oil resistant up to 160°C
- Chemical resistant
- Smooth surface
Jotun Tankguard Plus is especially designed as an internal lining for offshore, onshore and buried tanks and pipes such as chemical storage, waste water, grey water, process water, concrete bund, fire service lines and drilling mud tanks. This coating has very good resistance to high temperature products.
Application
Preparation
- Carbon Steel: Sa 2½ (ISO 8501-1)
- Stainless Steel: Abrasive blast cleaning to achieve a surface profile using non-metallic abrasive media which is suitable to achieve a sharp and angular surface profile.
- Galvanised Steel: Sweep blast-cleaning using non-metallic abrasive leaving a clean, rough and even pattern.
- Concrete: Dry abrasive blast cleaning to SSPCSP 13/NACE No. 6.
Application Method
- Spray: Use airless spray.
- Brush: Recommended for stripe coating and small areas, care must be taken to achieve the specified dry film thickness.
- Roller: Roller application only to be used for scallops, ratholes, small pipes etc.
See application guide sheet for full details.
Heat Resistance
- Dry, atmospheric: 160°C continuous
- Immersed, seawater: 90°C continuous, 95C peak
- Immersed, crude oil: 160°C continuous
Technical Info
| Components: | Two Pack |
| Type: | Polyamine cured phenolic / novolac epoxy |
| Finish: | Semi Gloss |
| Stock Colours: | Buff and White |
| Tintable: | No |
| VOC Content: | 342.0g per Litre |
| Volume Solids: | 70% ± 2 % |
| Suitable Substrates: | For properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates. |
| Application Method: | Airless Spray, Brush, Roller |
| Theoretical Coverage: | 4.7 - 7 m2 per litre per coat |
| Wet Film Thickness (WFT): | 140 - 215 microns |
| Dry Film Thickness (DFT): | 100 - 150 microns |
| Induction Time: | 15 minutes at 23°C |
| Pot Life: | 2 hours at 23°C |
| Touch Dry: | 4 hours at 23°C |
| Overcoatable: | 20 hours at 23°C |
| Fully Cured: | 5 days at 23°C |
| Cleaner / Thinner: | Jotun Thinner No. 23 |
| Shelf Life: | 24 months |
| Packaging: | Available in 20 Litres |
