£9.95 delivery on orders excluding certain products & postcodes *
Centrecoat SF Hygienic Floor and Tank Coating is a 2 pack product that provides decorative protection to concrete, steel and various other substrates.
Ideal for use as a waterproof, tough, chemical resistant floor coating in manufacturing and food preparation areas, warehouses, factories and breweries.
Also suitable as an internal lining for concrete or steel storage tanks containing oils, chemicals, water, raw sewage, etc. Contact our technical team for specific chemical resistivity.
Available in a wide range of BS4800 and RAL colours on request.
Provides excellent resistance to dilute acids, dilute alkalis, oil, petrol, diesel, vegetable oils, raw sewage etc. Please consult our technical department for specific advice.
Preparation
Do not apply to wet or uncured concrete surfaces. The minimum application temperature is 5°C. Please note that curing times will be significantly extended at low temperatures. Under certain site conditions below 10°C there is a risk of whitening (blooming).
Concrete shall be a minimum of 21 days old and/or the residual moisture content shall be below 6%. Ensure that the concrete is clean and free from dust, laitance, grease, oil, curing compound and existing paint finishes etc. Blow holes and defective concrete shall be made good using a proprietary repair compound e.g. Centrecoat MMA Repair Mortar or Centrecoat Epoxy Paste Adhesive.
Diamond grinding or shot blasting is the preferred preparation method prior to application as this ensures that a suitable mechanical ‘key’ is achieved.
Steel surfaces shall be shot blasted or grit blasted to a nominal Sa 2.5 Swedish standard. All dust and grease shall be removed prior to coating application. If a delay is likely to occur between blasting and application then it is recommended that a coat of Centrecoat 2 Pack Anti-Corrosive Primer is applied as a holding primer to obviate flash rusting.
Priming
Porous or dusty surfaces shall be primed using Centrecoat 525 WB Primer. Damp surfaces shall be primed using Centrecoat 2 Pack DPM. Please consult the relevant product data sheets for further information.
Mixing
Pour the contents of the CURING AGENT container into the BASE container and thoroughly mix by mechanical means until a uniform colour is achieved.
Application
Spread using a squeegee where appropriate and/or apply by roller at a rate of 0.25-0.3kg per m². Following overnight cure apply a second coat at the same rate. To achieve a slip-resistant finish then, depending on the profile required, either incorporate a suitable texturing additive or broadcast an appropriate aggregate immediately on to the 1st coat. Brush off excess aggregate prior to applying the 2nd coat.
Components: | Two Pack |
Type: | Epoxy |
Finish: | |
Stock Colours: | Just tints |
Tintable: | Yes, to most RAL or British Standard codes. Please note, bespoke tints are non refundable / exchangeable |
VOC Content: | |
Volume Solids: | |
Suitable Substrates: | Concrete, Steel, Tank Linings, Floors |
Application Method: | Squeegee |
Theoretical Coverage: | Typical application rate 0.25 – 0.3kg per m² per coat. Minimum of 2 coats recommended. |
Wet Film Thickness (WFT): | |
Dry Film Thickness (DFT): | |
Induction Time: | - |
Pot Life: | 45 minutes at 20°C |
Foot Traffic Ready: | 24 hours at 20°C |
Vehicle Traffic Ready: | 48 hours at 20°C |
Fully Cured: | 7 days at 20°C |
Cleaner / Thinner: | Clean equipment with Centrecoat MMA Tool Cleaner prior to curing of the coating. |
Shelf Life: | Minimum shelf life of 12 months when stored in original, unopened containers in accordance with the manufacturer’s instructions. |
Packaging: | Available in 5 and 15 Kg |