Remmers Arte Mundit is a self-vulcanising cleaning paste for thorough, water free removal of dust, soot, nicotine residue and other soiling on interior walls, ceilings, floors, stucco, natural stone, marble, concrete, brick, render, gypsum sculptures, polished wood, synthetic materials, etc.
Remmers Arte Mundit is an environmentally correct cleaning paste on a natural raw material base. The fresh product vulcanises by drying into an elastic rubber with good soil binding capacity. Arte Mundit does not contain any organic solvents, surface active agents or inorganic salts.
The A-components in the Arte Mundit programme differ in their reactivity and compatibility with auxiliary agents. Arte Mundit Type I is a modified latex emulsion that
is always used without an additive. After activation with the B component, Arte Mundit Types II, III and V contain varying concentrations of complexing agents and
cleaning intensifiers that either volatilize during vulcanisation or are bound into the dry film.
A contamination of the substrate with these substances is therefore not possible.
- Cleans practically all surfaces, also sensitive, valuable substrates.
- Easy to apply by spray or brush
- No chemical after-effects
- User-friendly and highly efficient
- Existing salts are not dissolved again in the stone mass
- Cleans also pores and deeper profiles
An introduction to working with Arte Mundit should be given before work is started.
The substrate to be cleaned must be dry and free form dust and loose deposits. All surfaces not to be treated, varnished areas, sensitive metals, etc. should be protected from contact with Arte Mundit (e.g. by covering with PE film).
Temperature of material, surroundings and substrate: +5°C - +30°C. Stir Arte Mundit well, add the B component if required, mix thoroughly and then apply to the substrate which has been coarsely cleaned with a brush, using a suitable tool and covering the entire surface. Fill undercut areas and contours thoroughly with Arte Mundit.
After thorough drying, the film is removed by carefully pulling it off (e.g. from the top left towards the bottom right), keeping tensile force as constant as possible. This is carried out in general approx. 24 hours after application. Avoid waiting times that are longer (more than 3 days) since the elasticity of the film is lost, making it much more difficult to pull off.
When Arte Mundit Type I is used, the surfaces do not need to be washed off afterwards. Surfaces treated with the activated Types II, III and V are cleaned again after the vulcanised material has been pulled off by wiping off with a sponge dampened with just a little clean water, starting at the highest point. If necessary, a medium-hard (nylon) brush can be used for somewhat more intensive cleaning. Use as little water as possible.
|Components:||One or Two Part (Type I is One Part, II, III and V are Two Part)|
|Suitable Substrates:||For internal cleaning|
|Application Method:||Brush, lambskin roller, filling knife and smoothing trowel. We recommend the use of stainless steel or plastic tools.|
|Theoretical Coverage:||m2 per litre at microns|
|Wet Film Thickness (WFT):||-|
|Dry Film Thickness (DFT):||-|
|Cleaner / Thinner:||-|
|Shelf Life:||At least 12 months in unopened, original containers stored dry, cool and protected from frost.|
|Packaging:||Available in 18.84 Kg|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.