TeknosPro 7 can be applied to concrete, plaster, filler, brick and to various building boards. It can also be used for repainting old alkyd and dispersion paint coats.
Clean new surfaces from dust and dirt. Wash previously painted surfaces with Rensa Super paint cleaner. Sand hard or gloss surfaces and remove the dust. Remove all of the old paint from the surfaces which have been painted with glue paint or lime wash. Spray filler ceilings, which are not waterproof, are recommended to be primed with a solvent borne primer e.g. Futura 3 Adhesion primer. For smoothing of irregularities in the surface choose a suitable filler from the Teknospro series. The dried filler is sanded down and the dust removed.
Prime concrete, plaster, stopper, brick and building board surfaces with Teknospro Pohja Primer. Steel surfaces are primed with Ferrex Aqua Anticorrosive paint. Before use stir the paint thoroughly. The paint is thinned with water when needed. Apply once or twice by brush, roller or spray. Suitable nozzle for airless spray is 0.017 - 0.021".
|Stock Colours:||Just tints|
|Tintable:||Yes to RAL, BS Shades. Please note, bespoke tints are non refundable / exchangeable|
|VOC Content:||max. 30 g/l|
|Suitable Substrates:||Concrete, plaster, filler, brick and to various building boards|
|Application Method:||Brush, Roller or Airless Spray. Suitable nozzle for airless spray is 0.017 - 0.021"|
|Drying Time - Dust Free:||After ½ hour at 23°C|
|Cleaner / Thinner:||Thinner: Water, Clean up: Wash equipment immediately after use with detergent and warm water|
|Packaging:||Available in 2.7 and 9 Litres|
The manufacturers data sheets are available for download from this website. It is your responsibility to read and understand all aspects of the data sheets before you place an order and prior to application. Please pay special attention to the preparation, mixing and application temperatures of the product, cleaning of substrate and environmental factors such as temperature, rain etc. Quoted coverage rates are based on the manufacturers theoretical rates and may vary depending upon substrates absorption, texture and application. We always recommend a test is carried out to ensure suitability.
Customer further agrees that Promain have no liability for any errors or omissions contained within the Product Data Sheets and are not liable for failure due to misapplication or inadequate substrate cleaning and preparation. For more information please refer to our Terms & Conditions.