£9.95 delivery on orders excluding certain products & postcodes *
A 2 pack epoxy zinc phosphate primer, primarily formulated to meet the requirements of the UK Highways Agency specification.
A low VOC, high solids, rapid cure primer/finish. Excellent anti-corrosive qualities and long term colour / gloss durability.
A two component, low VOC, high solids, fast curing epoxy primer / finish containing zinc phosphate anti-corrosive pigmentation.
A 2 part, abrasion resistant pure epoxy. Provides excellent long term anti-corrosive protection offshore or below water.
A low VOC, 2 pack, internally flexibilised, high build, low temperature curing down to -5°C.
A high performance, low VOC, water borne 2 pack epoxy with a high gloss finish for structural steel and concrete floors.
A 2 pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).
A phosphoric acid based mordant solution for treating galvanised steel. Highways Approved No. 155.
A two component acrylic polyurethane finish giving excellent durability and long term recoatability.
A two pack, epoxy acrylic isocyanate free cosmetic finish providing good long term durability as a finish coat.
For use on a wide variety of substrates including hand prepared rusty steel.
A low VOC, high performance, two component, isocyanate free cross-linking acrylic finish.
A patented technology, high performance, low VOC single pack acrylic polysiloxane finish coat containing no free isocyanates.
A single component, anti corrosive, one coat, rapid drying modified alkyd primer / finish.
A two pack epoxy abrasion resistant coating, containing micaceous iron oxide.
A suitable thinner for various products within the International range.
Epoxy barrier coat designed to give long term protection. LuL APR No. 2081.
Provides rapid cure and overcoating even under low temperature conditions.
A single component, water based acrylic finish for use in industrial environments.
An epoxy primer which provides optimised control where thin film application is required.
A very high solids, low VOC, two component high build epoxy containing a high level of chemically resistant glass flake.
A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.
A tough, hard wearing finish coat for application over properly primed surfaces.
A tough 2 pack epoxy finish coat For concrete that offers good abrasion and chemical resistance in corrosive environments.
Provides excellent long-term colour / gloss retention. Extended lifetime to first maintenance as part of a high end anti-corrosive system.