Full Product Catalogue

Two component high solids, high build, polyamide cured epoxy coating designed for general purpose protection to steel and concrete structures.

A one part, solvent borne, intumescent coating, optimised for 60 minutes for protection of structural steel against cellulosic fires.

Waterborne intumescent coating for fire protection of structural steelwork.

A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.

A two component epoxy anti-corrosive primer pigmented with zinc phosphate for anti corrosive protection.

A two component, high solids low VOC epoxy micaceous iron oxide.

Provides up to 60 minutes cellulosic fire protection over a wide range of I section beams and columns and hollow sections in interior environments.

A two pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).

A two component pure epoxy paint which cures to an abrasion and corrosion resistant coating.

A two-component, zinc rich epoxy primer which offers cathodic protection of local mechanical damage.

Two pack polyamide cured, zinc rich coating suitable for structural steel and piping exposed in corrosivity categories up to C5.

A very low VOC, single pack, waterborne acrylic thin film intumescent coating for passive fire protection of structural steel against cellulosic fires...

Formulated to provide up to 60 minutes fire protection on internal 'I' sections beams, columns and hollow sections.

A protective enamel coating for structures found in severe atmospheric conditions and is Network Rail approved.

A single component waterborne acrylic thin film intumescent coating for use to provide fire protection of structural steel exposed to cellluosic fire ...

A water based CEP free thin film intumescent coating to provide fire resistance up to 120 minutes on structural steel.

A fast drying, anti corrosive, high solids 2 part polyamide cured zinc rich epoxy coating.