£9.95 delivery on orders excluding certain products & postcodes *
A protective enamel coating for structures found in severe atmospheric conditions and is Network Rail approved.
A water based CEP free thin film intumescent coating to provide fire resistance up to 120 minutes on structural steel.
A fast drying, anti corrosive, high solids 2 part polyamide cured zinc rich epoxy coating.
Formulated to provide up to 60 minutes fire protection on internal 'I' sections beams, columns and hollow sections.
A two component epoxy anti-corrosive primer pigmented with zinc phosphate for anti corrosive protection.
Provides up to 60 minutes cellulosic fire protection over a wide range of I section beams and columns and hollow sections in interior environments.
A two component pure epoxy paint which cures to an abrasion and corrosion resistant coating.
A two-component, zinc rich epoxy primer which offers cathodic protection of local mechanical damage.
2 pack high solids, high build, polyamide cured epoxy for general purpose protection to steel and concrete structures.
A 1 pack waterborne acrylic thin film intumescent coating. For structural steel exposed to cellluosic fire up to 120 minutes.
A 2 pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).
2 pack polyamide cured, zinc rich coating suitable for structural steel or piping exposed in corrosivity categories up to C5.
A very low VOC, 1 pack, waterborne acrylic thin film intumescent coating for passive fire protection of structural steel against cellulosic fires.
A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.
A single component, anti corrosive, one coat, rapid drying modified alkyd primer / finish.
A 1 part, solvent borne, intumescent coating, for 60 minutes for protection of structural steel against cellulosic fires.