Full Product Catalogue

A single pack thin film 120 minute intumescent coating designed for in shop application to structural steel.

A water based TCEO free, thin film intumescent coating for up to 90 minutes fire protection on structural steel.

A water based CEP free thin film intumescent coating to provide fire resistance up to 120 minutes on structural steel.

A fast drying, anti corrosive, high solids 2 part polyamide cured zinc rich epoxy coating.

Bollom Brosteel Ultra 60 intumescent paint fire proof paint for steelwork. Provides up to 60 minutes resistance.

A rust inhibiting primer which is suitable for finishing with both single and 2-pack paints and finishes.

A two component moisture curing inorganic zinc ethyl silicate coating. Heat resistant up to 540°C.

A two component amine cured epoxy coating designed for new construction where short dry to handle and over coating times are required.

Specially designed as a universal, all round, new construction coating. Can be used as primer, mid coat, finish coat or as single coat system.

An industrial detergent used for degreasing oily or soiled surfaces prior to painting.

A low VOC, high solids, rapid cure primer/finish, offering excellent anti-corrosive protection and long term colour and gloss durability.

A two component, high solids, low VOC, epoxy zinc phosphate/micaceous iron oxide primer.

A two pack, epoxy acrylic isocyanate free cosmetic finish providing good long term durability as a finish coat.

A tough, hard wearing finish coat for application over properly primed surfaces.

For use on a wide variety of substrates including hand prepared rusty steel.

A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.

A low VOC, high performance, two component, isocyanate free cross-linking acrylic finish.

A two component epoxy anti-corrosive primer pigmented with zinc phosphate for anti corrosive protection.

A two part, abrasion resistant pure epoxy coating pigmented with aluminium to give excellent long term anti-corrosive protection offshore or below wat...

A two component, rapid recoat, fast curing solvent based inorganic zinc rich ethyl silicate primer.

A high performance, low VOC, water borne two component epoxy with a high gloss finish for use on structural steel and concrete floors.

Complete with MIO, Intercure 200HS can speed up production and throughput in fabrication shops.

A two component, high solids low VOC epoxy micaceous iron oxide.

Suitable for use as a finishing coat for protection of structural steel.

A two part, chemical and abrasion resistant, glass flake reinforced vinyl ester for the internal lining of chemical storage tanks and vessels.

Provides up to 60 minutes cellulosic fire protection over a wide range of I section beams and columns and hollow sections in interior environments.

A two component, low VOC, high solids, fast drying polyaspartic semi-gloss primer/finish coating.

A two pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).