£9.95 delivery on orders excluding certain products & postcodes *
Very good fouling coating that assures a totally active surface continuously renewed providing a clean hull for the whole season.
A two component moisture curing inorganic zinc ethyl silicate coating. Heat resistant up to 540°C.
A solvent based intumescent coating for structural steel exposed to internal environments up to corrosivity category C4 (ISO 12944-2).
A low film build anti-corrosive primer for application to steel substrates. Network Rail/Railtrack approved. Highways Approved Item No. 109
Formally Jotun Penguard Tie Coat. A two component, polyamide cured, high molecular weight epoxy coating, specially designed as a tie coat / sealer.
A two component polyamide highly pigmented zinc phosphate coating. Highways Approved Item No. 110.
A fast drying, two pack zinc phosphate pigmented, high solids and high build paint. Highways Approved Item No. 111.
A two component MIO micaceous iron oxide pigmented amine curing epoxy. Highways Approved Item No.112.
A two component solvent free amine cured phenolic/novolac epoxy coating. Specially designed tank lining with very good chemical resistance.
A two component coating for use in atmospheric and immersed environments.
A hard wearing top coat for use in aggressive atmospheric exposure. Network Rail approved. Highways Approved Item No 168
A two pack, high solids, high gloss topcoat for industrial use in offshore corrosive environments. Cures down to 0°C.
Two pack polyamide cured, zinc rich coating suitable for structural steel and piping exposed in corrosivity categories up to C5.
A two pack polyamine cured phenolic / novolac epoxy coating that is specially formulated for tank lining.
A high end surface tolerant epoxy mastic for less severe exposures or when shorter maintenance intervals are expected in tougher environments.
A two component protective coating for use in high traffic, atmospheric and immersed environments.
A single pack polysiloxane topcoat formulated to give a cosmetic finish with superior colour and gloss retention. NORSOK approved.
A topcoat for use in atmospheric environments, on a wide range of industrial structures. Replaces Pioner Topcoat.
A two component surface tolerant, high solids, high build coating. NORSOK approved.
A single pack, water borne acrylic emulsion topcoat for use over Jotun intumescent systems.