Full Product Catalogue

A two component epoxy for use as a primer or coating for steel and concrete structures. Highways Approved Item No. 116

A two component topcoat for the protection of structural steel in severely corrosive atmospheric environments.

A two component epoxy mastic coating for repair and maintenance.

Suitable for use in a range of markets where durable performance and aesthetics are needed.

2 pack high solids, high build, polyamide cured epoxy for general purpose protection to steel and concrete structures.

A high performance 2 pack single coat shop applied protective finish for structural steel that will not normally require further site coats.

A 2-part, polyurethane topcoat, with good gloss and colour retention. BBA Cert No. 08/H135-PS13. Highways Approved Item No.169.

A fast drying, two part amine cured epoxy zinc phosphate pigmented, high solids, high build product formulated for exposed structural steel.

A 2 pack amine cured epoxy coating for new construction where short dry to handle and over coating times are required.

A universal, all round, new construction coating. Used as primer, mid coat, finish coat or as single coat system.

A low VOC, high solids, rapid cure primer/finish. Excellent anti-corrosive qualities and long term colour / gloss durability.

A 2 part, abrasion resistant pure epoxy. Provides excellent long term anti-corrosive protection offshore or below water.

A high performance, low VOC, water borne 2 pack epoxy with a high gloss finish for structural steel and concrete floors.

A 2 pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).

A 2 pack semi-gloss acrylic polyurethane topcoat, cured with aliphatic isocyanate, with good gloss and colour retention.

2 pack polyamide cured, zinc rich coating suitable for structural steel or piping exposed in corrosivity categories up to C5.

A two pack, epoxy acrylic isocyanate free cosmetic finish providing good long term durability as a finish coat.

For use on a wide variety of substrates including hand prepared rusty steel.

A low VOC, high performance, two component, isocyanate free cross-linking acrylic finish.

Epoxy barrier coat designed to give long term protection. LuL APR No. 2081.

A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.

A tough, hard wearing finish coat for application over properly primed surfaces.

2 part, chemical / abrasion resistant, glass flake reinforced vinyl ester. For the internal lining of chemical storage tanks.

A high solids, low VOC epoxy barrier coat, reinforced with chemically resistant high aspect ratio lamellar glass flake.

A solvent free coating designed for installation onto steel or concrete surfaces.

A two component, solvent free epoxy which can be applied underwater and will cure underwater.

A solvent free coating designed for installation onto steel or concrete surfaces.

A solvent free coating designed for installation onto steel or concrete surfaces.