Full Product Catalogue

A single component, water based acrylic finish for use in industrial environments.

Formulated to provide up to 60 minutes fire protection on internal 'I' sections beams, columns and hollow sections.

Provides up to 2 hours fire protection on 'I' sections beams (including cellular beams), columns and hollow sections.

A high performance, high build, solvent free, two pack modified epoxy intumescent fireproofing coating.

A water-based rust remover which is 100% biological degradable and free from toxins.

A single pack solvent-based thin film intumescent coating for up to 60 minutes on structural steel.

A 2 pack amine cured epoxy coating for new construction where short dry to handle and over coating times are required.

A universal, all round, new construction coating. Used as primer, mid coat, finish coat or as single coat system.

A low VOC, high solids, rapid cure primer/finish. Excellent anti-corrosive qualities and long term colour / gloss durability.

A two component, high solids, low VOC, epoxy zinc phosphate/micaceous iron oxide primer.

A two pack, epoxy acrylic isocyanate free cosmetic finish providing good long term durability as a finish coat.

A tough, hard wearing finish coat for application over properly primed surfaces.

For use on a wide variety of substrates including hand prepared rusty steel.

A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.

A low VOC, high performance, two component, isocyanate free cross-linking acrylic finish.

A two component, rapid recoat, fast curing solvent based inorganic zinc rich ethyl silicate primer.

A high performance, low VOC, water borne 2 pack epoxy with a high gloss finish for structural steel and concrete floors.

Complete with MIO, Intercure 200HS can speed up production and throughput in fabrication shops.

A two component, high solids low VOC epoxy micaceous iron oxide.

Suitable for use as a finishing coat for protection of structural steel.

A two component, low VOC, high solids, fast drying polyaspartic semi-gloss primer/finish coating.

A 2 pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).

A single component, anti corrosive, one coat, rapid drying modified alkyd primer / finish.

A two pack epoxy filler for pitted steel or as an anode shield in marine environments.

A two component, low VOC, high solids, fast drying polyaspartic gloss primer/finish coating.

A two component pure epoxy paint which cures to an abrasion and corrosion resistant coating.

A two-component, glossy acrylic polyurethane coating for use onto structural steel in severely corrosive environments.

A 2 pack semi-gloss acrylic polyurethane topcoat, cured with aliphatic isocyanate, with good gloss and colour retention.