Full Product Catalogue

Sigma AquaCover 400 two component polyamine cured water borne epoxy coating for steel and concrete.

Formally Amercoat 385 PA. A high build poly amide cured zinc phosphate epoxy primer.

Two component high solids, high build, polyamide cured epoxy coating designed for general purpose protection to steel and concrete structures.

A high build polyamide cured recoatable epoxy coating.

A two component epoxy for use as a primer or coating for steel and concrete structures. Highways Approved Item No. 116

A high performance 2 pack single coat shop applied protective finish for structural steel that will not normally require further site coats.

A 2-part, polyurethane topcoat, with good gloss and colour retention. BBA Cert No. 08/H135-PS13. Highways Approved Item No.169.

A fast drying, two part amine cured epoxy zinc phosphate pigmented, high solids, high build product formulated for exposed structural steel.

A two component topcoat for the protection of structural steel in severely corrosive atmospheric environments.

Epoxy barrier coat designed to give long term protection. LuL APR No. 2081.

A low VOC, high solids, rapid cure primer/finish, offering excellent anti-corrosive protection and long term colour and gloss durability.

A two component, high solids, low VOC, epoxy zinc phosphate/micaceous iron oxide primer.

A two pack, epoxy acrylic isocyanate free cosmetic finish providing good long term durability as a finish coat.

A tough, hard wearing finish coat for application over properly primed surfaces.

For use on a wide variety of substrates including hand prepared rusty steel.

A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.

A low VOC, high performance, two component, isocyanate free cross-linking acrylic finish.

A two component epoxy anti-corrosive primer pigmented with zinc phosphate for anti corrosive protection.

A two part, abrasion resistant pure epoxy coating pigmented with aluminium to give excellent long term anti-corrosive protection offshore or below wat...

A two component, rapid recoat, fast curing solvent based inorganic zinc rich ethyl silicate primer.

A high performance, low VOC, water borne two component epoxy with a high gloss finish for use on structural steel and concrete floors.

Complete with MIO, Intercure 200HS can speed up production and throughput in fabrication shops.

A two component, high solids low VOC epoxy micaceous iron oxide.

Suitable for use as a finishing coat for protection of structural steel.

A two part, chemical and abrasion resistant, glass flake reinforced vinyl ester for the internal lining of chemical storage tanks and vessels.

A two component, low VOC, high solids, fast drying polyaspartic semi-gloss primer/finish coating.

A two pack, heat resistant, zinc silicate shop (pre-construction) primer providing good corrosion protection (even after heating up to 800°C).

A two pack epoxy filler for pitted steel or as an anode shield in marine environments.