£9.95 delivery on orders excluding certain products & postcodes *
Sigma AquaCover 400 two component polyamine cured water borne epoxy coating for steel and concrete.
Formally Amercoat 385 PA. A high build poly amide cured zinc phosphate epoxy primer.
Two component high solids, high build, polyamide cured epoxy coating designed for general purpose protection to steel and concrete structures.
A two component epoxy for use as a primer or coating for steel and concrete structures. Highways Approved Item No. 116
A high performance 2 pack single coat shop applied protective finish for structural steel that will not normally require further site coats.
A 2-part, polyurethane topcoat, with good gloss and colour retention. BBA Cert No. 08/H135-PS13. Highways Approved Item No.169.
A fast drying, two part amine cured epoxy zinc phosphate pigmented, high solids, high build product formulated for exposed structural steel.
A two-pack epoxy paint coating that is reinforced with glass flake. Highways Approved Item No.123.
A two component fast drying coating. Can be applied on steel, aluminium and concrete at sub zero surface temperatures.
A two component fast drying coating. Can be applied on steel, aluminium and concrete at sub zero surface temperatures.
A protective enamel coating for structures found in severe atmospheric conditions and is Network Rail approved.
An 2 pack epoxy zinc rich anti corrosive primer for the protection of steel surfaces.
A fast drying, anti corrosive, high solids 2 part polyamide cured zinc rich epoxy coating.
A two component moisture curing inorganic zinc ethyl silicate coating. Heat resistant up to 540°C.
A two component amine cured epoxy coating designed for new construction where short dry to handle and over coating times are required.
Specially designed as a universal, all round, new construction coating. Can be used as primer, mid coat, finish coat or as single coat system.
A low VOC, high solids, rapid cure primer/finish, offering excellent anti-corrosive protection and long term colour and gloss durability.
A two component, high solids, low VOC, epoxy zinc phosphate/micaceous iron oxide primer.
A two pack, epoxy acrylic isocyanate free cosmetic finish providing good long term durability as a finish coat.
A tough, hard wearing finish coat for application over properly primed surfaces.
For use on a wide variety of substrates including hand prepared rusty steel.
A two component epoxy zinc phosphate / micaceous iron oxide primer suitable for low temperature overcoating.
A low VOC, high performance, two component, isocyanate free cross-linking acrylic finish.
A two component epoxy anti-corrosive primer pigmented with zinc phosphate for anti corrosive protection.
A two part, abrasion resistant pure epoxy coating pigmented with aluminium to give excellent long term anti-corrosive protection offshore or below wat...
A two component, rapid recoat, fast curing solvent based inorganic zinc rich ethyl silicate primer.
A high performance, low VOC, water borne two component epoxy with a high gloss finish for use on structural steel and concrete floors.