NORSOK Approved Paints

A two component flint reinforced solvent free polyamine cured, epoxy compound suitable for the protection of steel and concrete.

A 3 part, high solids, surface tolerant, abrasion resistant anti-corrosive epoxy coating with a selected blend of fused aluminium oxide.

A two component fast drying coating. Can be applied on steel, aluminium and concrete at sub zero surface temperatures.

A self-primed, surface tolerant coating with low temperature curing properties, low VOC and high film build.

A protective enamel coating for structures found in severe atmospheric conditions and is Network Rail approved.

A one pack coating that contains 96% zinc to provide cold galvanizing cathodic protection of ferrous metals.

A high build, 2 pack epoxy, zinc phosphate primer / buildcoat for the anti corrosive protection of steel.

A versatile high performance polyamide cured epoxy designed to fulfil the needs of both new construction and maintenance painting to steel, aluminium ...

A 2 part surface tolerant high solid glass flake epoxy coating primarily designed for use in offshore splash zone maintenance.

A self curing solvent based zinc silicate coating for the protection of blast cleaned steel surfaces up to 400°C.

This product is now discontinued. See Sherwin Williams Zinc Clad IV EU as a potential alternative.

A two pack isocyanate free finish based on an acrylic epoxy binder system. NORSOK M501 Rev 6 System 1.

A high solids 2 pack epoxy, pigmented with MIO (Micaceous Iron Oxide) certified under Highways Agency No112.

An 2 pack epoxy zinc rich anti corrosive primer for the protection of steel surfaces.

A two pack, solvent free, thick film epoxy exterior intumescent coating that provides passive hydrocarbon fire protection for up to 4 hours on structu...

A flake filled MIO amine cured epoxy phenolic novolac formulated for use under thermal insulation at elevated or cryogenic temperatures.

A fast drying, anti corrosive, high solids 2 part polyamide cured zinc rich epoxy coating.

A 2 part polyamine cured epoxy coating with good chemical resistance formulated for use as a primer, mid coat or finish coat.

A two component epoxy coating for carbon and shop primed steel and coated surfaces. Can be applied at sub zero surface temperatures.

A 2 pack high build anti-corrosive epoxy mastic which can be applied in high film thicknesses for smaller maintenance and repair jobs.

A corrosion, abrasion, chemical and water resistant coating, suitable for interior and exterior use.

A two pack, high solids, high gloss topcoat for industrial use in offshore corrosive environments. Cures down to 0°C.

Immersion grade coating for steel and stainless steel. Cures down to 5°C. Tintable to a huge range of RAL and BS shades.

Immersion grade primer for use within a system for steel and stainless steel. Cures down to 5°C.

A single pack silicone high performance finish for areas exposed to extreme temperatures. Suitable for service from 204°C - 540°C.

Offers exceptional barrier protection and resistance to wet/dry cycling at elevated temperatures.

An ultra high solids epoxy that is designed as a liner for potable water. FDA approved.

Rapid / low temperature curing inorganic zinc product suitable for C3 - CX and immersion environments.